Allstar Products Group 3000, J3500, 3500-P owner manual Final Installation, Final Alignment and Test

Page 14

C: INSTALLING THE OPERATOR

104383

STEP 4 : Final Installation

A.Attach the"U" brackets to the "L" brackets with a 1/4-20 carriage bolt, washer and hex nut (provided). Insert the bolt from the inside of the "U" bracket and hand tighten only at this time.

B.Place the transmitter and receiver units into their respective "U" brackets. See Illustration, above.

C.Connect the interconnect wire pair to the garage door opener terminals marked "B" & "C". Although not required, it is suggested that the "trace" be connected to Terminal B. See Wiring Diagram, Page 21.

STEP 5 : Final Alignment and Test

A.Reconnect the power to the Garage Door Opener. Keep a portable transmitter with you to control the garage door opener.

B.Place a solid object one foot in front of the transmitter or receiver. The red LED should go OFF and remain OFF until the object is removed. NOTE: There may be a slight delay in returning to normal depending upon how long the photosystem was blocked.

C.Move to the center of the door. Make sure the red LED light is on. Move a solid object slowly through the beam. The LED should go OFF and then ON. If not, check the wire connections (see Step 3).

D.At this time set or recheck the down limit adjustment and reversing system adjustment of the garage door opener following the procedure outlined in Steps 1 & 4, Pages 17 & 18. It is VERY IMPORTANT that the door opener's inherent features operate as intended before completing the photosystem tests.

E.Place an opener insert box or a similar object (at least six inches high) on the floor at the center of the door. Now, attempt to close the door. The door should NOT close from the portable transmitter, but will close with constant pressure from the mechanical push button.

F.Remove the obstruction from the photosystem beam’s path. Close the door. Toward the bottom of the doors downward movement, CAREFULLY move a solid object across the path of the beam at the center of the door. The door should STOP, pause for approximately one second and OPEN. Retest, breaking the beam one foot in front of both the transmitter and receiver unit while the door is moving downward. The door must STOP and OPEN each time. If not, re-align the photosystem until proper operation is obtained.

G.Tighten all mounting screws and bolts.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Series Table of Contents Product Features Optional FeaturesComponent Identification Tools RequiredAssembly Instructions StepImportant Installation To Reduce the Risk of Severe Injury AdjustmentInstalling the Operator Do not Attempt AdjustmentMounting the Front Bracket One High ARC Rise High ARC Rise Horizontal LineOne Piece Doors without Track Raise the opener Mount Power Head to CeilingSectional Doors and One Piece Doors with Track Mounting straps in the slots closest to FrontDoor ARM Connection and Installation Connect the standard wall Push Button provided to Mount at least 5 FT from the floor to prevent small childrenFastening Limit CAM to Chain Connect the Photosystem as follows Auxiliary EquipmentPhotosystem Unit is Within the Limit Marks on the Door Jamb Final Installation Final Alignment and TestInstallation of Radio Controls If the Door is Operating ParametersCheck with Your Local Building Inspector First ONE SECOND, and then Begin Moving Upward104390 Operation and Adjustment Instructions Warni NGTesting the All-Clear Photosystem Security Switch is GarageOperator Wiring Diagram Wiring Auxiliary Equipment Series Connection Receiver FirstInstallation Checklist Solution Troubleshooting GuideSymptom Probable CAUSE/SOLUTION Probable CauseAllstar Corporation Downingtown, PA
Top Page Image Contents