Allstar Products Group 3000, J3500, 3500-P owner manual Door ARM Connection and Installation

Page 10

C: INSTALLING THE OPERATOR

FIBERGLASS, ALUMINUM OR LIGHTWEIGHT STEEL GARAGE DOORS WILL REQUIRE REINFORCEMENT BEFORE CAUTION! INSTALLATION OF DOOR MOUNTING BRACKET. CONTACT YOUR DOOR MANUFACTURER FOR A REINFORCEMENT KIT

STEP 6: DOOR ARM CONNECTION AND INSTALLATION

NOTE: If the door is of light construction it may be necessary to reinforce the center stile with steel angle or wood to prevent damage to the door if it encounters an obstruction on closing.

104376

ONE PIECE DOORS

WITHOUT TRACKS

DOOR MOUNTING

BRACKET ON TOP OF

DOOR

SECTIONAL DOORS AND ONE-PIECE DOORS WITH TRACKS: Install the door mounting bracket on center and even with the top set of rollers on the door as illustrated. Connect the straight Door Arm section (single hole end) to the Trolley using a clevis pin and clip provided. Connect the curved Door Arm section (single hole end) to the door mounting bracket using a clevis pin and clip, provided. The Door Arm must pivot freely. Connect the two Door Arm sections with the 5/16" nuts and bolts provided, adjusting the length of the Door Arm so that it leans toward the Power Unit as illustrated. Do not install the Door Arm so that it is straight up and down when the door is closed or the Emergency Release will not function properly.

ONE-PIECE DOORS WITHOUT TRACKS: Install the Door Mounting Bracket on the top edge of the door at center as illustrated. Connect the curved Door Arm section (single hole end) to the Trolley using a clevis pin and clip provided. Connect the straight Door Arm section (single hole end) to the door mounting bracket using a clevis pin and clip, provided. The Door Arm must pivot freely. Connect the two Door Arm sections with the 5/16" nuts and bolts provided, adjusting the length of the Door Arm so the straight portion is at a 15-20 degree angle with respect to the floor.

104377

SECTIONAL DOORS AND ONE

PIECE DOORS

WITH TRACK

DOOR MOUNTING

BRACKET EVEN WITH

ROLLERS

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Series Table of Contents Product Features Optional FeaturesComponent Identification Tools RequiredAssembly Instructions StepImportant Installation To Reduce the Risk of Severe Injury AdjustmentInstalling the Operator Do not Attempt AdjustmentMounting the Front Bracket One High ARC Rise High ARC Rise Horizontal LineOne Piece Doors without Track Raise the opener Mount Power Head to CeilingSectional Doors and One Piece Doors with Track Mounting straps in the slots closest to FrontDoor ARM Connection and Installation Connect the standard wall Push Button provided to Mount at least 5 FT from the floor to prevent small childrenFastening Limit CAM to Chain Photosystem Unit is Within the Limit Marks on the Door Jamb Auxiliary EquipmentConnect the Photosystem as follows Final Installation Final Alignment and TestInstallation of Radio Controls If the Door is Operating ParametersCheck with Your Local Building Inspector First ONE SECOND, and then Begin Moving Upward104390 Operation and Adjustment Instructions Warni NGTesting the All-Clear Photosystem Security Switch is GarageOperator Wiring Diagram Wiring Auxiliary Equipment Series Connection Receiver FirstInstallation Checklist Solution Troubleshooting GuideSymptom Probable CAUSE/SOLUTION Probable CauseAllstar Corporation Downingtown, PA
Top Page Image Contents