Allstar Products Group LT 50 HOW to Operate the Door Manually Manual Release Disconnect

Page 19

F: OPERATING INSTRUCTIONS

HOW TO OPERATE THE DOOR MANUALLY - MANUAL RELEASE DISCONNECT

The door should be fully closed, if possible, before using the manual disconnect. Weak or broken springs could allow an open door to fall rapidly. Property damage or serious personal injury could result. Do not use the manual release handle to pull the door open or closed.

Your opener is equipped with a manual release recessed trolley-type disconnect system, enabling manual operation of the garage door during a power failure.

The trolley is disconnected from the chain by pulling down on the red release handle, allowing the garage door to be operated manually.

The trolley will automatically reconnect when power is restored and the door is activated.

If the manual release is used, close the door before reactivating the opener.

NOTE: Outside keylock manual releases are an available accessory and are recommended for garages without a service entrance.

Trolley

Manual

Release

Knob

110058-1

OPTIONAL THREE FUNCTION WALL STATION

When the Wall Station is connected to the operator per instructions supplied with the wall station, it will provide the following features:

1.“OFF-ON” will prevent inadvertent operation of the door from any other push button, radio or keyless entry device. It will also as additional protection from unwanted operation during absence of the owner. This feature is to be activated only when the door is at the full open or close position and never while the door is moving.

2.“LIGHT” button allows the convenience light to be turned on and stay on until turned off by a second push of the button or activation of the door cycle.

3.“UP/DOWN” button provides normal opening and closing of the door by momentary activation of this push button. Function of door cycle is described above - “How the Door Moves When the Opener is Activated”.

109986

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents
Allstar LT Table of Contents Standard Features Product FeaturesOptional Features Tools Required Component IdentificationAssembly Instructions Page Reinforce the Header Wall Installing the OperatorSectional Doors and ONE-PIECE Doors With Track Door Bracket Installation Mount Power Head to CeilingProvided to Terminals 1 & 0 on the Openers rear Install a Rough Service lamp bulb 75 WattConnecting The Electrical Power Connect the standard wall Push ButtonMounting the Photosystem Wall Brackets Select a mounting Optional Safe Finish Photosystem InstallationWire Connect the Photosystem Final Installation of Photosystem UnitsAlignment and Initial Test of Safe Finish Photosystem AT this Point Plug Connect the Power to the OperatorConnecting the Door Arm to the Door Connecting Door Arm to TrolleyPhotoelectric Obstruction Test Important Test Opener Obstruction Sensing FeatureTance is inadequate Try moving Adjustment #3 Obstruction Sensing at Close Limit Position AdjustmentsAdjustment #1 Opening Travel Adjustment #2 Opening and Closing ForceChecking the Travel Timer Adjustments / Important Safety InstructionsAdjustment #3 Obstruction Sensing Closing Direction Adjustment #4 Positive Mechanical Lock AdjustmentOperation of Your Opener Operating InstructionsOptional Three Function Wall Station HOW to Operate the Door Manually Manual Release DisconnectOptional Pneumatic Door Edge Installation Safe Finish Wiring Diagram / Door Edge InstallationMaintenance of Your Opener Maintenance Schedule / Installation ChecklistInstallation Checklist Symptom Probable CAUSE/SOLUTION Troubleshooting GuideParts Breakdown & Listing Allstar Corporation Downingtown, PA Manufacturer’s Limited Warranty