Motor
Motor
Removal
1.Perform Pressure Relief Procedure, see page 4.
2.Remove Power Module, see page 7.
3.Disconnect material hose (79) from pump (18a).
79
18a
ti15616a
4.Remove four screws (40) and lift motor shroud (98) off of motor.
40
98
ti15624a
5.Disconnect three wire harnesses (see Wiring Diagrams, pages
6.Remove two screws (5b) from underneath motor base plate. Lift and remove motor/pump assembly from pump module.
5b
ti11734a
7.Loosen four screws (19) on bearing housing (9), and remove from gear housing.
5a
9
ti15630a
19
8.Remove three screws (5c) on motor (8a). Remove motor from gear housing.
5c
8a
ti11735a
Installation
1.Apply brown lithium grease supplied with motor repair kit (8) to gear cluster (17a) and inside of motor cavity.
17a | ti15629a |
|
2.Align orientation tab on gear housing with slot on motor and slide gears into motor.
3.Replace three screws (5c) on motor (8a). Torque to
5a
5c
8a
ti11735a
10 | 3A0246C |