Prime Valve Handle
Prime Valve Handle
Removal
1.Perform Pressure Relief Procedure, see page 4. Wait 5 minutes before servicing.
2.Use 3/32 in. punch and hammer to tap out handle pin (72c) (pliers may be required to pull out handle pin). Pull off handle (72a) and base (72b).
3.Use crescent wrench to unscrew prime valve (71).
NOTE: Make sure that the seat and gasket are removed from the manifold.
71
72c
72a
72b
4.Clear out any material that is lodged in valve (71) or manifold (70).
Installation
1.Tighten prime valve (71) into manifold (70). Use thread sealant on housing threads and torque to 190 to 210
2.Install prime valve base (72b). Pin in base must align with hole in manifold (70).
3.Orient hole in prime valve stem (71) vertically.
4.Place prime valve handle (72a) over prime valve base (72b) with handle in “apply” mode. Align hole in handle (72a) w/hole in prime valve stem (71).
5.Use hammer to tap prime valve handle pin (72c) back into place.
70
ti15633a
20 | 3A0246C |