Installation Instructions
Kitchen and Bath Main Faucet Filtration System – GXULQ/GNULQ
SAFETY PRECAUTIONS
•Check with your state and local public works department for plumbing and sanitation codes. You must follow these guidelines as you install the Kitchen and Bath Main Faucet Filtration System. Using a qualified installer is recommended.
•Be sure the water supply conforms with the Performance Data. If the water supply conditions are unknown, contact your municipal water company.
WARNING — Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
•It is highly recommended that a water
PARTS INCLUDED
•Filter Cartridge
•Filter Head/Bracket
•6 Feet of 3/8″ Tubing
•3/8″ x 1/2″ Faucet Adapter
•3/8″ Compression Hex Nut
•3/8″ Ferrule
•3/8″ Tube Insert
•Mounting Screws
•1/2″ Compression to 3/8″ Adapter
•7/16″ Compression to 3/8″ Adapter
Optional accessories are available (Visa, MasterCard or Discover cards accepted) by visiting our Website at ge.com or from Parts and Accessories, call 800.626.2002 (U.S.) or 800.663.6060 (Canada).
TOOLS YOU WILL NEED
Screwdriver
Utility Knife
Adjustable Wrench
Drill with 1/8″ Drill Bit
PROPER INSTALLATION
This Kitchen and Bath Main Faucet Filtration System must be properly installed and located in accordance with the Installation Instructions before it is used.
•Check with your local public works department for plumbing codes. You must follow their guides as you install the Kitchen and Bath Main Faucet Filtration System.
•Use the Kitchen and Bath Main Faucet Filtration System on a potable,
•Protect the Kitchen and Bath Main Faucet Filtration System and piping from freezing. Water freezing in the system will damage it.
•Your Kitchen and Bath Main Faucet Filtration System will withstand up to 100 psi water pressure. If your house water supply pressure is higher than 100 psi during the day (it may reach higher levels at night), install a pressure reducing valve before the system is installed.
•Do not install on HOT WATER. The temperature of the water supply to the Kitchen and Bath Main Faucet Filtration System must be between the minimum of 40°F and the maximum of 100°F. See the Performance Data section.
•Do not install the Kitchen and Bath Main Faucet Filtration System using copper solder fittings. The heat from the soldering process will damage the unit.
WARNING — Discard all unused parts and packaging material after installation. Small parts remaining after installation could be a choke hazard.
•Do not install filter in an outside location or anywhere it will be exposed to sunlight.
System is Tested and Certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine, Taste and Odor and Particulate Class I and Standard 53 for the reduction of Turbidity.
238C3375P001 | 1 | Printed in China |