Faceplate Timer Features
4.Press SELECT again to show the following RECHARGE display.
EXAMPLE: Set to 4 days maximum between regenerations.
Maximum Days Between Regenerations: The face plate timer automatically controls regeneration frequency. This provides the greatest operating effi- ciency, and under most conditions this feature will be left in its default mode. However, you can modify this feature if you want to force a regeneration every set number of days. For example, if your water supply contains iron and you want the softener to regener- ate at least once every few days to keep the resin bed clean, set the display as typically shown above. Setting is available from 1 to 6. Press SELECT to return to the present time is play.
5.Press SELECT to show the 97% display.
IntelliSoft 97% Feature: The 97% Feature is an inte- gral part of the IntelliSoft water and salt saving sys- tem. When this feature is ON, the softener will auto- matically recharge when 97% capacity has been used, at any time of day. The default is ON. If this feature is not desired, turn it off by pressing the DOWN button.
6.Press SELECT to show the 12 HOUR display.
12 or 24 hour clock: All time displays are shown in standard clock time (1 to 12 PM; and 1 to 12 AM) at the 12 hr default setting. If Military time displays are desired, set to 24 hr by pressing the UP button.
DAY
RECHARGE
Default Display
RECHARGE
AM
PM
TIME
DAY
RECHARGE
Example:
Set to 4 Days Maximum Between Regeneration
RECHARGE
TIME
WATER FLOW THROUGH THE SOFTENER
If soft water is in use, the water flow bars continually scroll across the display. The bars scroll slowly when water flow is slow, and move faster as water flow increases. The flow bars do not show when all faucets and water using appliances are off.
Flow bars scroll when soft water is in use.
FIG. 37
Questions? Call The Kenmore Water Line
24