Service Tech Information
WATER FLOW THROUGH THE SOFTENER VALVE
SERVICE CYCLE
SERVICE CYCLE
Hard water enters the valve inlet port. Internal valve porting routes the water down and out the top distributor, into the resin tank. Hard water is softened as it passes through the resin bed, then enters the bottom distributor. Soft water flows back into the valve and out the valve outlet, to the house soft water pipes.
To Valve Inlet 
(Soft Water) 
Bottom
Distributor
From Valve Inlet
(Hard Water)
Top Distributor
Resin Tank
Position
Switch
FIG. 59
FILL CYCLE
To begin a regeneration, the electronic timer ener- gizes the circuit to the valve motor. The valve motor rotates the rotor and disc and the valve cam until the position switch lever drops, to open the motor circuit and position the valve in FILL. As the rotor and disc rotates, the port opens for SOFT water fin through the venturi. Fill flow continues to the brine valve, and into the salt storage tank. Soft water is still available to the house lines.in.
position switch
fill flow
plug 
fill water 
(soft)
To Valve Outlet
(Soft Water)
bottom
distributor
FILL CYCLE
valve cam
rotor & disc
from Valve Inlet
(hard water)
Top Distributor
Resin Tank
Position
Switch
FIG. 60
BRINING AND BRINE RINSE CYCLE
BRINING AND BRINE RINSE CYCLES
After fill, timer/switch action allows the motor to turn the rotor and disc into BRINING position. Water flow is directed to the nozzle. Suction, creat- ed by the nozzle and venturi, draws brine from the salt storage tank and injects it into the resin bed via the bottom distributor. Flow continues out the top distributor and to the drain. Hard water is avail- able at the valve outlet.
When the brine valve closes to end brine draw, water flow continues in the same directions to slowly RINSE brine from the resin bed and to the drain.
Venturi
Nozzle
Brine from Salt
Storage Tank
Bypass Hard
Water To
Valve Outlet
Drain
from valve inlet
(Hard Water)
Position
Switch
FIG. 61
Questions? Call The Kenmore Water Line
40