Custom Fit Connections - Plastic Sleeve Installation Instructions
Correct method
1.Identify desired length of tube (1). Leave 1" - 2" of extra length to allow for easier installation and cut tube. Ensure cut is straight and burr free.
2.Slide nut (2) and plastic sleeve (3) onto cut tube. Ensure sleeve is oriented as shown.
3.Insert tube into outlet fitting (4). Tube should touch bottom of hole inside fitting.
4.Slide plastic sleeve down tube until it engages
top of fitting. WARNING: Failure to use plastic |
|
| 2 | |
| ||||
|
sleeve in the correct orientation will result in disconnection and possible water damage.
5.Slide nut over plastic sleeve. With wrench,
tighten nut 2 turns past finger tight. | 3 |
| |
| 1 |
| 4 |
Incorrect Installation
1
2
Do not install sleeve | Do not use RP51243 Ensure cut is straight. | Ensure tube is fully |
upside down. | gasket (1) supplied | inserted into stop |
| with PEX tubing or | before sliding sleeve |
| brass ferrule (2) | down to engage top |
| supplied with | of fitting. |
| valve stops. |
|
9