Sharp CV-2P10SC Install Window Panel, Installation in a double-hungsash window, guard net

INSTALL WINDOW PANEL

Installation in a double-hung sash window

1

2

Connect the rain guards to the insect	Insect guard net	Hole	Rain guard
guard net.
Insert all three projections on each rain
guard into the holes in the insect guard net.
Side “A” will now be at the top, as indicated
in the diagram.
	Projec-		"A"
	tion
Attach the guard combined above to	Projection
the window panel.	"A"		Window panel
Push the insect guard net firmly to ensure
that its four projections fit into the holes in
the window panel.
Side “A” will now be at the top, as indicated
in the diagram.

3 Cut the foam seal A to the proper length and attach it to the window stool.

4 Attach the window panel to the window stool.

Make sure that the exhaust cover is attached to the window panel.

Inner width of the window 21.3"(540mm) - 28.3"(718mm)

Use the window panel.

The window panel cannot be installed in windows less than 21.3" (540mm) wide, as you will be unable to shut the exhaust cover.

(1)Cut the window panel to the same width as the window.

(2)Open the window sash and place the window panel on the window sill.

(3)Secure the window panel to the window stool with 2 screws.

EN-10

Foam seal A

Exhaust cover

Window panel

Cut

21.3"-28.3"

CV-2P10SC_en.indd 10

11.3.22 11:00:13 AM