Operation of Your Opener
Activate the opener with any of the following:
•The Remote Control: Hold push button clown until the door starts to move.
•The Door Control: Hold push button down until the door starts to move.
•The Outdoor Key Switch or Keyless Entry: (See Accessories)
When the opener is activated with the safety reversing sensor installed and correctly aligned:
Weak or broken springs could allow an open door to fall (either rapidly or unexpectedly), resulting in serious injury, death or property
damage. If possible, use the emergency release rope and handle onlywhen the door is fully closed.
1.If open, the door will close, If closed, it will open.
2.If closing, the door will reverse.
3.If opening, the door will stop (allowing space for entry and exit of pets and for fresh air).
4.If the door has been stopped in a partially open position, it will close.
5.If obstructed while closing, the door will reverse.
6.If obstructed while opening, the door will stop.
7.The garage door will reverse in the closing cycle, and the opener lights will blink for 5 seconds, when the invisible beam is broken. If fully open, the door will not close when the beam is broken. The sensor has no effect in the opening cycle.
If the sensor is not installed, or is not aligned correctly, the door won'tclose from any remote transmitter. You can close the door with the Door Control, the Outdoor Key Switch, or Keyless Entry, however, if you activate them unti/down traveli$ complete. If you release them too soon, the door will reverse.
The Opener Lights will turn on under the following conditions: When the opener is initially plugged in; when the power is interrupted; when the opener is activated. It will turn off automatically after
SECURITY,l, models: Lights will also turn on when someone walks through the open garage door. With a Premium Control Console, this feature may be turned off as follows: With the opener lights off, press and hold the light button for 10 seconds, until the light goes on and off again. To restore this feature, start
with the opener lights on, then press and hold the light button for 10 seconds.
O O Release Yrm
Emergency
Manual disconnect
position
Release Arm
Trolley
Towards Opener)
Lockout position
To open the door manually:
The door should be fully closed if possible. Pull down on the red
emergency release handle and lift the door
manually. To reconnect the door to the opener, press the Door Control push button.
The lockout feature
prevents the trolley from reconnecting automatically.
Pull the emergency handle down and back (toward the opener). The door can then be raised and lowered manually as often as necessary. To disengage the Lockout Feature, pull the emergency handle
straight down. The trolley will reconnect on the next
UP or Down operation.
Operation of the Door Controls
(SECURITY+ models: Sea additional programming features, next page.)
Press the lighted push button to open or close the door.
Press again to reversethe door during the closing cycle or to stopthe door while it'sopening.
Premium Console:
Light Feature- Press the large round Light button. If the opener lights are off, they will turn on. If the opener lights are on, (even in the
But if you use the Light button to turn the lights on and then activate the opener, the lights will turn off after
The Light button will not control the opener lights when the door is in motion.
Premium Console (cont.):
Lock Feature - The Lock feature is designed to prevent operation of the door from remote controls. However, the door will open andclosefrom the Door Control, the Outdoor Key Switch and the Keyless
Entry Accessories.
To Activate: Press and hold the small round Lock
button for 2 seconds. The push button light will flash as long as the Lock feature is on.
To turn off"Press and hold the Lock button again for 2 seconds.The push button light will stop flashing. The Lock feature will also turn off whenever the "SRr" button on the opener panel is activated.
32