Assembly Step 2
Install the Trolley on the T-rail
•As a temporary stop, insert a screwdriver into the hole in the front end of the
•Slide the trolley assembly along the rail to the screwdriver stop.
If trolley hits against any nuts on the
Hex Screw
Temporary Stop
Screwdriver
Assembly Step 3 | I |
Fasten the | I |
|
Place the opener on packing material to protect the cover. For convenience, put a support under the belt pulley bracket.
Remove the (2)
Trolley
Stop Hole
\
.ock Washer
, _ 5/16"
/Nut
•Insert a
stop hole in the
trolley travel in the DOWN direction.
......
.;.:.;.:.:.:. :.:.:.:.:.::+:._.:.:.:.:+:.:.:.:.:.:+:;p
To fasten rail, use only those screws mounted in the top of the opener. Any other screws will cause serious damage to the opener.
Washered Screw
Align the holes in the back section of the
•Fasten the rail with the (2) washered screws previously removed. Tighten securely.
Remember to use only these screwsl Any other screws will cause serious damage to the opener.
•Insert a
NOTE: This screw prevents trolley
Hardware Shown Actual Size
DHlilllilililill0
Hex Screw | NUt | Lock Washer |
Hex Screw
Cover
Protection
(Sack Section)
5/16"
Nut
Use Or#,
5/16"- 18x7/8" | 5/16" | 5/16" |