Installation Step 9 | I |
Electrical Requirements | I |
|
To reduce the risk of electric shock, your garage door opener has a grounding type plug with a third ]rounding pin. This plug will onlyfit into a grounding type outlet.
If the plug doesn't fit into the outlet you have, contact a qualified electrician to install the proper outlet.
To avoid installation difficulties, do not run the opener at this time,
To prevent electrocution or fire, installation and wiring must be in compliance with local electrical and building codes.
Do NOTuse an extension cord,
your outlet.
If permanent wiring is required by your local
To make a permanent connection through the 7/8" diameter hole in the top of the opener (according to local code):
•Remove the opener cover screws and set the cover aside.
•Remove the attached
•Connect the black (line) wire to the screw on the brass terminal; the white (neutral) wire to the screw on the silver terminal; and the ground wire to the green ground screw. The opener must be grounded.
•Reinstall the cover.
To avoid installation difficulties, do not run the opener at this time.
code, refer to the following procedure:
Permanent
Wiring
Connections
GroundTab
Green
Screw
| Black |
Wire | i Wire |
White Wire
Wire
2O