Craftsman 139.53664SRT2 owner manual 8OO-366-PART, Product Type Part Number Model Description

Page 40

For professional installation

Call 24 hours a day, 7 days a week

1-8OO-865-6500

For the repair or replacement parts you need

Call 7 am - 7 pro, 7 days a week

1-8OO-366-PART

(1-800-366-7278)

For in-home major brand repair service

Call 24 hours a day, 7 days a week

1-8OO-4-REPAIR

(1-800-473-7247)

For the location of a Sears Repair Service Center in your area

Call 24 hours a day, 7 days a week

1-800-488-1222

For information on purchasing a Sears Maintenance Agreement

or to inquire about an existing Agreement Call 9 am - 5 pm, Monday-Saturday

1-800-827-6655

The model number label is located under the light lens on the front end panel of your opener. When requesting service or ordering pads, always give the following information:

• Product

Type

•

Part

Number

• Model

Number

•

Part

Description

r3

 

 

 

 

SEARS

America's Repair Specialists

SEARS WARRANTY

FULL 90-DAY WARRANTY ON GARAGE DOOR OPENER

For 90 days from the date of purchase, Sears will repair this Garage Door Opener, free of charge, if defective in material or workmanship,

LIMITED WARRANTY

From the 91st day until one year from the date of purchase, Sears will furnish replacement parts for any defective pads, free of charge.

You pay for labor.

LIMITED WARRANTY ON MOTOR

I/2HP MOTOR: After 1 year and through 5 years, if the motor on this Garage Door Opener is defective, Sears witl furnish a replacement motor, free of charge. You pay for labor.

LIMITATION ON LIABILITY

SEARS WILL NOT BE LIABLE FOR LOSS OR DAMAGE TO PROPERTY OR ANY INCIDENTAL OR CONSEQUENTIAL LOSS OR EXPENSE FROM PROPERTY DAMAGE DUE DIRECTLY OR INDIRECTLY FROM THE USE OF THIS PRODUCT. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply 1o you.

This warranty does not cover light bulbs or repair pads necessary because of operator abuse or negligence, including the failure to insta[I, adjust and operate this garage door opener according to instructions contained in the owner's manual.

WARRANTY SERVICE IS AVAILABLE BY SIMPLY CONTACTING THE NEAREST SEARS CENTER/DEPARTMENT IN THE UNITED STATES.

This warranty applies only while this product is in use in the United States.

This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

Sears, Roebuck and Co., Dept. 817WA, Hoffman Estates, IL 60179

114A2124C

©1997, All Rights Reserved

Printed in Mexico

Page 39 Page 40
Image 40
Page 39 Page 40
Contents CRRFTSMIiN Start by Reviewing these Important Safety Alert Symbols MechanicalElectricaLYoull Need Tools Otherwise, the safety reverse system may not Closed PositionIt must close on the floor all the way across Work properly. See page 30. Floor or door shouldOne-Piece Door with Track One-P ece Door without TrackHardw&faSlsenlguired Carton Inventory Installation Hardware Safety Reversing Sensor Installation HardwareAssembly Section Pages 8 Assembly StepAssemble the T-rail Attach the Belt Pulley Bracket Hardware Shown Actual SizeInstall the Trolley on the T-rail Fasten the T-rail to the OpenerPlace Install the Belt Set Belt TensionCheck to make sure the belt is not twisted Attach the Belt Cap Retainer To attach the belt cap retainerInstallation Section Installation Step #youneed to install the header bracketPages 12 Proceed to ,One-piece door without track Jamb hardware ExampleInstall the Header Bracket Fasten the Header Bracket to the WallFasten the Header Bracket to the Ceiling DoorHardware Shown Actual SizeAttach the T-rail Header Bracket Shown Actual SizePosition the Opener Opener could fall and injure someone if it Hang the OpenerIs not properly secured. Fasten the opener Install the Premium Control Console Install the Lights Lenses Install the lenses32 explains how to use the door control Install the lightsCode, refer to the following procedure If permanent wiring is required by your localElectrical Requirements Safety Reversing System Facing the door from inside the garageInstall the Safety Reversing Sensor Sensors will face each other across the garage doorFinger tighten the lock nuts Alternate Floor MountAligning the Safety Sensors Trouble ShootingFasten Door Bracket Bracket Hodzontal and vertical reinforcementScrewsnot provided Connect Door Arm to Trolley Hole Alignment AlternativeFasten the straight and curved door arm sections Adjustment Procedures for One-Piece DoorsTogether to the longest possible length, with a 2 or Adjustment Section Pages 28 Adjust the UP and Down LimitsHow and When to Adjust the Limits If the door does not close completelyAdjustment Step Adjust the ForceHow and When to Adjust the Forces Test the Down close forceTest The Safety Reversing Sensor Test the Safety Reverse SystemImportant safety check AdjustmentMaintenance To reduce the risk of severeInjury or death to persons Care of Your OpenerOperation of Your Opener Operation of the Door ControlsIf you have a Premium Control Console Receiver and Remote Control ProgrammingIf you do not have a Premium Control Console Probable Cause and Solution Having a Problem?Situation Probable Cause & Solution Rail Assembly Parts Repair PartsInstallation Parts Repair Parts Opener Assembly PartsFor Sectional Doors On12 AccessoriesIf you do not have Premium Control Console Index 8OO-366-PART Product Type Part Number Model Description
Top Page Image Contents