Sharp R-1900J x 2 8, To Reset the Counter to “0”, ProcedureDisplay, Air Intake Filter Counter

To Reset the Counter to “0”

Each counter can be manually reset to “0” by pressing the START pad after the count is displayed.

*Suppose you want to reset the count for memory number 1 in any Memory Input Method

Procedure

x 2 7 After about 1 sec.

1	Press the CUSTOM
	SETTING pad twice within
	2 seconds, then enter 7.
	Total usage will be			CHECK
	displayed.
2	Enter memory
		0
	number 1 to check
	the total memory
	usage of memory 1.
			NO.	CHECK
		1
			NO.	CHECK

After about 1 sec.

CHECK

3 Press the START pad. CHECK

Use Custom Setting function for Air Intake Filter Counter to change the Air Filter Cycle from 001-999. The factory setting is 100 hours. When 100 hours is exceeded, the FILTER indicator in the display will start to flash on and off as a reminder to clean the air filter, even if in the middle of cooking. Furthermore “FILt“ flashes on and off in stead of displaying “ . “ during standby and at the same time FILTER indicator flashes on and off. Clean air intake filter (see page 21), when the FILTER indicator appears in the display, and then clear the total usage to reset it to “0” .

*Suppose you want to know the total usage hours which has been 99 hours since the last reset.

ProcedureDisplay

x 2 8 1

1 Press the CUSTOM SETTING	After about 1 sec.
pad twice within 2 seconds
and enter 8, 1.
	CHECK

2Press the STOP/CLEAR pad to exit from the Custom Setting function.

To Reset the Air Intake Filter Counter

Reset the Air Intake Filter Counter after cleaning the air intake filter.

*Suppose you want to reset the Air Filter Counter which has been 101 hours since the last reset and the Air Filter Cycle is preset to 100.

ProcedureDisplay

4Press the STOP/CLEAR pad to exit from the Custom Setting function.

NOTES:

1.	Only Dual Digit Input method can be used when inputting
	memory numbers in Counter Check/Clear.
2.	To clear total manual cooking usage, press the MANUAL/
	REPEAT pad in Step 2 instead of the number pad.
3.	To clear total Express Defrost usage, press the EXPRESS
	DEFROST pad in Step 2 instead of the number pad.

x 2 8 1

1 Press the CUSTOM SETTING pad twice within 2 seconds and enter 8,1.

After about 1 sec.

CHECK FILTER

4. To clear total usage, skip Step 2.

8. Air Intake Filter Counter

Use Custom Setting function for Air Intake Filter Counter to check total usage hours since the Air Intake Filter Counter was last reset to “0”.

CU81 : The total used air intake filter time appears.

CU82 : The limit time for using a filter can be changed.

2Press the START pad to reset the counter to “0”.

3Press the STOP/CLEAR pad to exit from the Custom Setting function.

12

R-1900J [EN].indd Sec1:12

4/28/09 10:01:27 AM