Sharp R-1900J operation manual How to Remove the Splash Cover, How to Install the Splash Cover

Splash Cover:

AT LEAST ONCE A WEEK, REMOVE THE SPLASH COVER AND WASH BOTH SIDES OF IT IN A MILD DETERGENT SOLUTION. A BUILD UP OF GREASE MAY OVERHEAT AND BEGIN TO SMOKE AND MAY BURN THE SPLASH COVER. THE SPLASH COVER IS LOCATED IN THE TOP OF THE OVEN AND MAY EASILY BE REMOVED. REMEMBER TO UNPLUG THE POWER CORD. INSTALL THE SPLASH COVER PROPERLY. OPERATING THE OVEN WITH AN INCORRECTLY INSTALLED SPLASH COVER MAY DAMAGE THE COMPONENTS IN THE OVEN CAVITY AND SHORTEN THE EXPECTED LIFE SPAN OF YOUR OVEN.

SPLASH COVER (Frame + Cover)

Remove the splash cover as shown in Fig. 2 and separate the frame from the cover.

How to Remove the Splash Cover

Remember to unplug the power cord. Turn the 2 tabs holding the oven ceiling cover to the oven cavity ceiling as shown in Fig. 2, then gently pull the cover downwards to separate from the oven cavity ceiling. Then separate the cover from the frame. It is held in place by 4 catches.

COVER:

Wipe any grease, spills or spatters on the oven ceiling cover with a soft cloth dampened with a mild detergent solution. Don’t soak the splash cover in detergent or wash it.

FRAME:

Wipe any grease, spills or spatters on the frame with a soft cloth dampened with a mild detergent solution. Scrape hardened spills or spatters with a plastic spatula. Don’t use metallic brushes or sharp-edged tools, as scratches on the frame may cause the frame to warp or break during heating. To remove hardened spills or spatters, soak the frame in a mild detergent solution for a short period of time. Don’t use detergent with orange oil, as the frame may melt.

How to Install the Splash Cover

Remember to unplug the power cord. Replace the cover in the frame. Insert projection A (2) into the 2 holes in the rear cavity wall and then insert projection B (2) into the 2 holes in the oven cavity ceiling as shown in Fig. 2. Then slide the tabs in place.

ANTENNA COVER

If antenna cover has grease, spills or spatters, wipe antenna cover with a soft cloth dampened with a mild detergent solution. Don’t use metallic brushes or sharp-edged tools, as scratches on the antenna cover may cause the cover to warp or break during heating.

Splash Cover

Projection A

Tab

Tab

Splash Cover

Hole

Antenna Cover

Ceramic Shelf

Fig.1

	Frame
Projection B
	Projection A
Catch	Cover
	Catch

Hole Pin

	Screw
Hole	Air intake filter

Fig.2

Fig.3 Splash Cover

Keep the air intake filter clean. Clean the air intake filter once every two weeks. (equivalent to 100 hours usage) or more often for heavy use. See Custom Setting 8 Air Intake Filter Counter on page 12. Loosen the screw holding the air intake filter to the oven and move the air intake filter to the left a little bit to remove the air intake filter from the pin.

Wash the air intake filter in mild soapy water, rinse and dry with a soft cloth. After cleaning re-install the air intake filter.

The screw can be loosened and tightened either by hand or by using a coin.

DO NOT OPERATE THE OVEN WITHOUT THE AIR INTAKE FILTER IN PLACE.

21

R-1900J [EN].indd Sec1:21

4/28/09 10:01:29 AM