Moving the appliance, For your safety | Electrolux EIKG5547 instruction

be installed and connected in accordance with the current installation regulations. Particular attention shall be given to the rel- evant requirements regarding ventilation. The room containing the appliance should have an air supply in accordance with BS. 5440: Part 2 Current Edition.

All rooms require an openable window or equivalent and some rooms will require a permanent vent as well.

For room volumes up to 5m3 an air vent of 100cm2 is required: for room volumes be- tween 5m3 and 10m3 an air vent of 50cm2 is required.

If the room has a door that opens directly to the outside, no air vent is required.

For room volumes that exceed 11m3 no air vent is required.

If there are other fuel burning appliances in the same room, BS.5440: Part 2 Current Ed- ition should be consulted to determine the requisite air vent requirements.

Prolonged intensive use of the appliance may call for additional ventilation, for example opening a window, or more effective ventila- tion, for example increasing the level of me- chanical ventilation where present.

Moving the appliance

You may damage some soft or badly fitted floor coverings when you move the appli- ance.

The floor covering under the appliance should be securely fixed so it does not ruck up when you move the appliance across it. Alternatively you could remove the floor cov- ering.

This appliance is heavy and care must be taken when moving it.

Do not try to move the appliance by pulling the door handles.

To move the appliance open the grill door. Raise the appliance off its front feet by lifting it from inside the oven. Pull the appliance for- ward.

When you replace the appliance push it back to the stop and make sure there is the same gap at each rear corner.

For your safety

Do not try to disconnect the appliance from the gas supply if the supply pipe does not have a bayonet connection, as described in the installation instructions. If this is the case

electrolux 21

contact the person who installed the appli- ance.

Location of the appliance

This appliance must not be installed in a bed- sitting room of volume less than 20m3 or in a bathroom, shower room or garage.

It is essential that the appliance is positioned as Fig 1. a.

Shelves, wall cabinets and cooker hoods must be fitted a minimum of 750mm directly above the top of the hotplate (or greater for cooker hoods if recommended by manufac- turers instructions) and 400mm above the hotplate when fitted in line with the outside of the appliance.

If the units are intended to be fitted adjacent to the appliance but less than 400mm above the hotplate, then a minimum space of 50mm must be maintained between the sides of the unit and the appliance as Fig 1.b. Curtains must not be fitted immediately be- hind the appliance or within 150mm of the sides of the hotplate.

If fitted next to or between two base units a minimum space of 2mm must be left be- tween each unit and the sides of the appli- ance.

The levelling feet fitted to the appliance will achieve a nominal height to hotplate of 907mm + / - 5mm.

Fig 1.a

Fig 1.b

L.P.G. cookers MUST NOT be installed below ground level i.e. in a basement or aboard any boat, yacht or other vessel.

Levelling the appliance

Adjustment to suit floor conditions or height is obtained by rotating clockwise or anti clockwise the feet at the front and rear of the appliance.

EIKG5546, EIKG5547 specifications

Electrolux has a strong reputation in the world of kitchen appliances, and their EIKG5547 and EIKG5546 models exemplify this commitment to quality and innovation. These freestanding cookers are designed for versatile cooking, making them ideal for both amateur cooks and seasoned chefs.

One of the standout features of the EIKG5547 and EIKG5546 is their efficient energy management. Both models come with an A energy rating, ensuring that they not only save on electricity costs but also contribute to a more sustainable environment. Energy efficiency is increasingly important for consumers, and these cookers deliver without compromising performance.

The EIKG5547 is equipped with four gas burners, each featuring a flame failure safety device. This technology ensures that if the flame goes out, the gas supply will be automatically cut off, providing peace of mind. The EIKG5546, while also featuring four burners, offers a different flavor with one powerful wok burner that provides additional heat for those larger pots, making it exceptionally versatile for stir-fry dishes or heavy-duty cooking.

Cooking is simplified in both models with the inclusion of a spacious oven. The EIKG5547 features a 70-liter capacity, while the EIKG5546 offers a slightly smaller option. Both ovens come equipped with a conventional heating system, ensuring even cooking results while making it ideal for baking. The ovens also include an easy-to-clean enamel interior that prevents food residue from sticking, making maintenance a breeze.

In terms of design, both the EIKG5547 and EIKG5546 feature a sleek stainless-steel finish that complements any modern kitchen decor. Their contemporary knobs and controls are intuitively placed for ease of use, allowing for seamless cooking experiences. In addition, the glass oven door provides visibility into the cooking process without needing to open the oven and release heat.

Aside from their impressive features, these cookers are designed with durability in mind. The robust construction and high-quality materials used ensure longevity, making them a wise investment for any household. Whether you're boiling, simmering, baking, or roasting, Electrolux’s EIKG5547 and EIKG5546 cookers stand out as reliable, high-performing options that bring convenience and efficiency to cooking. With a blend of safety, energy efficiency, and modern aesthetics, these appliances perfectly cater to contemporary culinary needs.