20electrolux
Problem
The hob burners will not light.
The flame colour is orange/yellow.
The burner is not igniting or only partially lighting.
The burner sounds noisy.
The burner is emitting a popping sound.
Noise.
Possible solution
Ensure the burner parts have been placed cor- rectly.
Check that there is not a problem with your gas supply. You can do this by making sure the other gas appliances such as central heating or gas fires are working.
Due to the design of the burner the flame can ap- pear to be orange /yellow (flame disturbance) in certain areas of the burner this is a natural occur- rence.
Check that the burner is dry and that food spillage or cleaning fluids are not present on the burner. This can be dried with a cloth and stubborn marks cleaned away with a dry nylon brush (old tooth- brush etc).
It is natural for the burners to emit noise as the gas is being drawn through the burner and may re- duce as they heat up.
This is a natural occurrence when the burner is alight and does not affect the performance of the burner.
It is normal for some metal parts on the cooker to produce noise when in use, this is due to expan- sion and contraction when heating up and cooling down.
Installation instructions
Important safety requirements
Warning! This appliance is not suitable for installation in flats or other mutli occupancy dwellings as defined in clause 8.2.1 of IGE/G/5.
Where applicable Natural Gas and L.P Gas versions of this appliance are available. Check that this model is suitable for the type of supply available.
This appliance must be installed and/or serv- iced by a competent person, in accordance with the Gas Safety (Installation and Use)
Regulations Current Editions and the IEE Wiring Regulations.
For appliances installed in the Republic of Ireland please refer to NSAI - Domestic Gas Installation IS813 Current Editions and the ETCI Rules for Electrical Installations.
In the Republic of Ireland a signed Declara- tion of Conformity is issued by the installer (IS813 Currents Editions Annex D.1).
Detailed recommendations are contained in the following British Standard Codes of Prac-
tice – BS.6172, BS.5440: Part 2 and B.S. 6891. All British Standards must be ‘Current Editions’.
Warning! This appliance must be installed by a qualified electrician / competent person (CORGI Registered). Safety may be impaired if installation is not carried out in accordance with these instructions.
Before connecting the appliance make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. This is situated on the lower front frame of the appliance and can be seen upon opening the door.
Alternatively the rating plate may also be found on the back or top of some mod- els (where applicable).
Do not alter the electrical circuitry of this appliance.
Provision for ventilation
This appliance is not connected to a com- bustion products evacuation device. It shall