Electrolux DFKTWC75GS installation instructions Prepare the hood

Page 10

10Installation

Prepare the hood

NOTE

On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces of the hood and decorative flues, prior to final installation.

1.Remove the polystyrene block and the tape (Fig.1).

2.The back plate shown in Fig. 2 must be removed: remove the (4) screws of the back plate, operating from the inside of the hood (Fig. 3).

3.Remove the tape on the electrical system plate; place the electrical system plate on the hood (protect surface from electrical system plate using cardboard protection). Fig. 4.

4.Remove the (2) screws of the back plate (Fig. 5) and discard the back plate.

POLYSTYRENE BLOCK

TAPE

FIG. 1

BACK PLATE

FIG. 3

ELECTRICAL SYSTEM PLATE
PROTECTION	FIG. 4
	FIG. 4

FIG. 2

FIG. 5

Image 10

Contents Use & Care Guide Installation Instructions Page Please read and save this guide Table of contentsFinding Information Keep a record for quick referenceSafety Important Safety InstructionsIntegral Disconnecting Switch Verify package contents Install the ductwork InstallationTo reduce the risk of fire, use only metal ductwork 33-7/16 WiringImproper grounding can result in a risk of electric shock Install mounting bracket Install flue mounting bracket DUCTEDANDNON-DUCTEDPrepare the hood Ducted CONFIGURATIONNON- Ducted Configuration Install the hood At least two people will be required to mount the hoodRooms with 10-FOOT Ceilings Prior to use, remove protective film from the filter frame Install filtersDucted and NON-DUCTED Hoods NON-DUCTED Hoods onlyGrease filters Hood cleaning MaintenanceNon-Ducted Recirculation filters Operation ControlsHalogen bulbs Fuse replacement Switch OFF the Electricity SupplyWarranty Information WarrantyPage 04307838/3S