Care and Cleaning, Service Centre | Electrolux 49002VMN instruction

6www.aeg.com

•If there is a crack on the surface, dis- connect the power supply. There is a risk of electric shock.

•Do not put heat-conducting materials (e.g. thin metal mesh or metal-plated heat conductors) under the cookware. Excessive heat reflection can damage the cooking surface.

•Do not use the appliance during a pow- er cut.

CARE AND CLEANING

•Before maintenance, make sure that the appliance is cold. There is a risk of burns. There is a risk that the glass pan- els can break.

•Keep the appliance clean at all times. A build-up of fats or other foodstuff can result in a fire.

•Regular cleaning prevents the surface material from deteriorating.

•For your personal safety and the safety of your property, only clean the appli- ance with water and soap. Do not use flammable products or products that can cause corrosion.

•Do not clean the appliance with steam cleaners, high-pressure cleaners, sharp objects, abrasive cleaning agents, abra- sive sponges and stain removers.

•If you use an oven spray, follow the in- structions from the manufacturer. Do not spray anything on the heating ele- ments and the thermostat sensor (if ap- plicable).

•Do not clean the glass door with abra- sive cleaning agents or metal scraper. Heat resistant surface of the inner glass can break and shatter.

•When the door glass panels are dam- aged they become weak and can break. You must replace them. Contact the service centre.

•Be careful when you remove the door from the appliance. The door is heavy.

•Bulb lamps used in this appliance are special lamps selected for household appliances use only. They cannot be used for the full or partial illumination of a household room.

•If it becomes necessary to replace the lamp use one of the same power and specifically designed for household ap- pliances only.

•Disconnect the appliance from the power supply before the replacement of the oven lamp. There is the risk of electrical shock. Cool down the appli- ance. There is a risk of burns.

•Do not clean catalytic enamel.

SERVICE CENTRE

•Only an approved engineer can repair or work on the appliance. Contact an approved service centre.

•Use only original spare parts.

DISPOSAL OF THE APPLIANCE

•To prevent the risk of physical injury or damage:

–Disconnect the appliance from the power supply.

–Cut off the mains cable and discard it.

–Discard the door catch. This prevents children or small animals from being closed inside of the appliance. There is a risk of suffocation.