Installation
Attaching Liebert XD Flex Pipe Support Panel
Use of only the lower Liebert XDCF module requires attaching a Liebert XD Flex Pipe support panel and three pipe retainers. The retainers keep the refrigerant pipes behind the Egenera cabinet. If an upper Liebert XDCF module will be used, the Liebert XD Flex Pipe retainers will be attached to the upper module.
To attach the Liebert XD Flex Pipe support panel:
1.Position the Liebert XDCF Liebert XD Flex Pipe support panel over the line of four holes above the right edge of the lower Liebert XDCF module
2.Secure the Liebert XD Flex Pipe support panel to the cabinet by inserting and tightening four screws on the panel’s flange. Tighten the fasteners securely with a screwdriver, either a Phillips or a
3.Attach the three pipe retainers:
a.Slip the front end of a retainer into a slot on the Liebert XD Flex Pipe support panel.
b.Insert a panel fastener into the retainer and thread it into the captive panel nut.
c.Tighten the fastener securely, using a screwdriver, either a
d.Repeat Steps a and c for the other retainers.
Figure 9 Liebert XD Flex Pipe support panel attachment
Liebert XD Flex Pipe support panel and retainers
Lower
Captive
Panel
Nut
Liebert XD
Flex Pipe
Support Panel
Captive
Panel
Nuts
Captive Panel
Fastener
Liebert XD
Flex Pipe
Retainers
CF unit
Captive Panel
Fastener
10