Emerson XDCF Mounting Lower Liebert Xdcf Module, Preparing the Lower Module for Attachment

Page 12

Installation

4.3Mounting Lower Liebert XDCF Module

The lower Liebert XDCF module attaches to the Egenera BladeFrame cabinet with a mounting bracket, four bolts and a metal stud.

Before the Liebert XDCF is mounted, the mounting bracket and a two-piece deflector panel must be attached to its top surface and insulation must be applied to the left side.

4.3.1Preparing the Lower Module for Attachment

1.Position the mounting bracket over the two mounting holes. The holes are near the center of the top of the Liebert XDCF module (see Figure 7).

2.Use two captive panel fasteners to attach the mounting bracket to the top of the Liebert XDCF module. Tighten the fasteners securely, using a screwdriver, either a blade-type or Phillips.

3.Position the top deflector over the two mounting holes along the front edge of the top of the lower Liebert XDCF module (see Figure 7). The flanges along the edge should be on the bottom.

4.Use two captive panel fasteners to attach the top deflector to the top of the lower Liebert XDCF module.Tighten the fasteners securely, using a screwdriver, either a Phillips or a blade-type.

5.Position the second piece of the top deflector along the front edge of the deflector piece attached in Steps 3 and 4, matching the mounting slots in the two pieces. The flanges along the edge should be on the bottom.

6.Use two captive panel fasteners to connect the deflector pieces. Tighten the fasteners finger-tight, leaving them loose enough to slide for good contact with the Egenera BladeFrame cabinet.

Figure 7 Lower Liebert XDCF attachments

Captive nuts for mounting bracket, 2

Mounting bracket and top deflector attached

to unit

Slots in front piece of deflector permit proper positioning

FRONT

Holes for attaching top deflector

RIGHT SIDE

FRONT

LEFT SIDE

Positioning Stud

8

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Liebert Xdcf Important Safety Guidelines Fluorinated Greenhouse Gas Requirements-European UnionTable of Contents Figures Liebert Xdcf component locations XD CF Example XD-CF10-BP-0References Parts Included With Liebert XdcfRoom Preparation General Product InformationProduct/System Description Equipment InspectionUnit Handling Unpacking the Liebert Xdcf Recyclable PackagingMechanical Considerations 134aInstallation Considerations InstallationMounting Lower Liebert Xdcf Module Preparing the Lower Module for AttachmentAttaching Lower Liebert Xdcf Module Locator hole for lower unit studAttaching Liebert XD Flex Pipe Support Panel Liebert XD Flex Pipe support panel attachmentAttaching Upper Liebert Xdcf Module Preparing the Upper Module for AttachmentAttaching Upper Liebert Xdcf Module Attaching Liebert XD Flex Pipe retainersPiping Connections and Piping Access Points European Union Fluorinated Greenhouse Gas RequirementsConnection Methods and Points Header SystemConnecting Liebert XD Flex Pipes to Liebert Xdcf Modules Recommended Piping SizeTools Required Liebert XD prefabricated piping assembly Tools Required Insulation Return Supply LineChecklist for Proper Installation Maintenance Fluorinated Greenhouse Gas RequirementsSpecifications Liebert Xdcf specificationsSpecifications Specifications Page Ne t
Top Page Image Contents