Bose 149393, 901 Series VI manual Before you begin, Unpacking the cartons

Page 5

English

Setting Up

Before you begin

Thank you for purchasing the Bose® 901® Series VI Direct/Reflecting® speakers. They represent the best in Bose Corporation speaker design and engineering and will give you many years of listening pleasure.

The installation and operating principles of this system are significantly different from those of conventional speakers. To obtain the best possible performance and avoid problems, please take the time to read this guide.

CAUTION: You must have a Bose 901 active equalizer for a complete 901 speaker system. The use of 901 Series VI speakers without the 901 Series VI active equalizer will result in improper per- formance. The use of graphic or parametric equalizers, instead of the Bose 901 equalizer, will result in unsatisfactory performance.

Conventional graphic and parametric equalizers may be used in addition to, but not in place of the Bose 901 active equalizer. However, the use of such additional equalizers is not recom- mended since it will not improve system performance. For adequate performance you must use the 901 Series VI active equalizer with these speakers.

Unpacking the cartons

A complete Bose 901 Series VI speaker system consists of three matched components: two 901 Direct/Reflecting® speakers and a separate 901 Series VI active equalizer. Two cables are included to connect the active equalizer to your receiver or amplifier. The 901 speakers and equalizer are packed in three separate cartons. Carefully unpack your system, saving all pack- ing materials for possible future use.

Inspect the speakers and equalizer. If any part appears damaged, do not attempt to use the system. Repack the speakers and equalizer in their original cartons and notify your authorized Bose dealer immediately.

Note: Now is a good time to record the serial numbers of each speaker and the active equalizer. Please write them on your warranty card and in the spaces provided on page 2. The serial num- bers are located on the bottom of the 901 speakers and on the back of the equalizer.

Warning: Each speaker carton weighs over 35 lb (16 kg). Use good lifting practice to avoid injury.

Warning: To avoid danger of suffocation, keep the plastic bags out of the reach of children.

Figure 1

What comes in the three cartons:

• Two 901 speakers

• One 901 active equalizer

• Two equalizer cables



Image 5
Contents Page Bose 901 Series VI Direct/Reflecting Please read this owner’s guide Additional safety informationFor your records Customer service Where to find…Warranty period Unpacking the cartons Before you beginSystem Compatibility Installation stepsChoose the support for your speakers Choosing the location for your speakersGeneral notes on ceiling suspension Step by step procedure for ceiling suspensionHardware needed for ceiling suspension Preparing the speaker wires Choosing the wireConnecting the speakers Speaker connectionsStereo/non-home theater use Equalizer ConnectionsChecking the speaker connections Home theater use Home theater receiver connections To test the Tape Monitor connection Testing the speakers and equalizerTo test the equalizer To test the PRE AMP OUT/MAIN AMP in connectionTo add a tape deck or VCR Using other equipmentPlaying your speakers When connected to Tape MonitorWhen connected to PRE AMP OUT/MAIN AMP Using the Bass control Adjusting the soundUsing the MID-TREBLE and MID-BASS sliders Equalizer compatibility Connecting additional speakersAdding 901 speakers Adding conventional speakersProblem What to do Cleaning your speakersTroubleshooting Technical information AccessoriesEuropean Office CanadaAustralia Belgique/BelgiëPage Bose 901 Series VI Direct/Reflecting Veuillez lire la présente notice d’utilisation Pour vos dossiersAutres consignes de sécurité Période de garantie Service clientOù trouver… Ouverture du carton d’emballage Avant de commencerCompatibilité du système Marche à suivre pour l’installationChoix d’un support pour les enceintes Disposition des enceintesInstructions pour la disposition Marche à suivre pour suspendre les enceintes Accessoires requis pour suspendre les enceintesRemarques générales pour suspendre les enceintes Câbles appropriés Connexion des enceintesPréparation des câbles Connexion des enceintesUtilisation Stéréo/non home theater connexions Tape Monitor Connexion de l’égaliseurVérification des connexions des enceintes Tape Monitor Utilisation home theater Connexions PRE AMP OUT/MAIN AMPConnexion d’un récepteur de Home Cinema Vérification d’une connexion PRE AMP OUT/MAIN AMP Vérification des enceintes et de l’égaliseurVérification d’une connexion magnétophone Tape Monitor Ajout d’un magnétophone ou magnétoscope Utilisation d’autres équipementsConnexion à la prise PRE AMP OUT/MAIN AMP Écoute des enceintesConnexion à la prise Tape Monitor Réglage des curseurs MID-TREBLE et MID-BASS Utilisation de la commande des BassesRéglage du son Connexion d’enceintes supplémentaires Compatibilité de l’égaliseurEnceintes 901 supplémentaires Enceintes conventionnelles supplémentairesDépannage Problème SolutionNettoyage des enceintes Informations techniques AccessoiresUSA