Bose 149393 manual Choosing the location for your speakers, Choose the support for your speakers

Page 7

English

Setting Up

Choosing the location for your speakers

Choose locations for your 901® speakers that use the walls to best advantage by reflecting sound throughout the listening room. Refer to the drawing on page 7.

Guidelines for placement

Place the speakers along the same wall (see Figure 3):

4 to 12 feet (1.2 – 3.6 m) apart, with the V-shaped rear of the speaker between 8 and 18 inches (20 – 45 cm) from the rear wall. Do not aim the V toward a corner.

18 inches (45 cm) of clear space around the sides, top, and bottom of the speakers.

at least 2 feet (60 cm) from sound-absorbent furnishings.

18 to 48 inches (45 – 120 cm) from the side and rear walls.

18 to 36 inches (45 – 91 cm) from the floor or ceiling. Do not place the speakers exactly halfway between floor and ceiling.

Within these guidelines, remember that the closer the speakers are placed to a reflective surface, like a wall, the more bass is reproduced.

Choose the support for your speakers

You may place 901 speakers on a table or shelf. You may also use Bose® floor pedestals, or suspend the speakers from your ceiling. Refer to Figure 3 on page 7.

Figure 2

Pedestal (A) and ceiling mount

(B) pilot holes

To set the speakers on a table or shelf

Although each speaker weighs 35 lb (16 kg), a suitable shelf or table must be able to support 140 lb (64 kg). Keep an adequate distance between the speakers and the rear wall as listed in “Guidelines for placement” above.

To stand the speakers on the floor

Use only Bose pedestals (PS-6) as floor stands. They are designed to provide the proper support and are available through your authorized Bose dealer. Please read the pedestal

attachment­ instructions before making any speaker connections. Four pilot holes on the

­bottom of each speaker (see Figure 2, hole set A) are pre-drilled for the purpose of anchoring the speaker to the pedestal.

To suspend the speakers from the ceiling

Use these guidelines to ensure safe suspension of your 901 speakers. Three steel support chains are recommended. We cannot specify the ceiling attachments. The type to use ­depends on the type of building construction.

CAUTION: Do not mount on surfaces that are not sturdy enough, or that have hazards con- cealed behind them, such as plumbing or electrical wire. If you are unsure of your ability to install these speakers, contact a qualified professional installer.

Note: The speakers hang in an inverted position, with the terminal connections facing up. ­Carefully rotate the Bose logo 180˚ (so it appears right side up) before hanging the speakers.

B

A

AA B

B A



Image 7
Contents Page Bose 901 Series VI Direct/Reflecting For your records Additional safety informationPlease read this owner’s guide Warranty period Where to find…Customer service Unpacking the cartons Before you beginSystem Compatibility Installation stepsChoose the support for your speakers Choosing the location for your speakersHardware needed for ceiling suspension Step by step procedure for ceiling suspensionGeneral notes on ceiling suspension Speaker connections Choosing the wirePreparing the speaker wires Connecting the speakersChecking the speaker connections Equalizer ConnectionsStereo/non-home theater use Home theater use Home theater receiver connections To test the PRE AMP OUT/MAIN AMP in connection Testing the speakers and equalizerTo test the Tape Monitor connection To test the equalizerTo add a tape deck or VCR Using other equipmentWhen connected to PRE AMP OUT/MAIN AMP When connected to Tape MonitorPlaying your speakers Using the MID-TREBLE and MID-BASS sliders Adjusting the soundUsing the Bass control Adding conventional speakers Connecting additional speakersEqualizer compatibility Adding 901 speakersTroubleshooting Cleaning your speakersProblem What to do Technical information AccessoriesBelgique/België CanadaEuropean Office AustraliaPage Bose 901 Series VI Direct/Reflecting Autres consignes de sécurité Pour vos dossiersVeuillez lire la présente notice d’utilisation Où trouver… Service clientPériode de garantie Ouverture du carton d’emballage Avant de commencerCompatibilité du système Marche à suivre pour l’installationInstructions pour la disposition Disposition des enceintesChoix d’un support pour les enceintes Remarques générales pour suspendre les enceintes Accessoires requis pour suspendre les enceintesMarche à suivre pour suspendre les enceintes Connexion des enceintes Connexion des enceintesCâbles appropriés Préparation des câblesVérification des connexions des enceintes Connexion de l’égaliseurUtilisation Stéréo/non home theater connexions Tape Monitor Tape Monitor Utilisation home theater Connexions PRE AMP OUT/MAIN AMPConnexion d’un récepteur de Home Cinema Vérification d’une connexion magnétophone Tape Monitor Vérification des enceintes et de l’égaliseurVérification d’une connexion PRE AMP OUT/MAIN AMP Ajout d’un magnétophone ou magnétoscope Utilisation d’autres équipementsConnexion à la prise Tape Monitor Écoute des enceintesConnexion à la prise PRE AMP OUT/MAIN AMP Réglage du son Utilisation de la commande des BassesRéglage des curseurs MID-TREBLE et MID-BASS Enceintes conventionnelles supplémentaires Compatibilité de l’égaliseurConnexion d’enceintes supplémentaires Enceintes 901 supplémentairesNettoyage des enceintes Problème SolutionDépannage Informations techniques AccessoiresUSA