Bose 901 Series VI, 149393 manual Home theater receiver connections

Page 12

Setting Up

2.Use the twin cable assemblies (with two connectors at each end) that are supplied with the equalizer. Use one connector for the right (R) channel connections and the other connector for the left (L) channel connections.

3.Connect the amplifier INPUT of the Bose® 901® active equalizer to the PRE AMP OUT jacks of the receiver or amplifier. Connect right channel to right channel and left to left.

4.Connect the amplifier OUTPUT of the active equalizer to the MAIN AMP IN jacks on the receiver or amplifier. Connect right channel to right channel and left to left.

5.Plug the power cord of the 901 active equalizer into one of the switched outlets on the receiver so that it will be powered when the receiver is switched on.

Note: This connection method does not allow you to connect a tape deck directly to the active equalizer. Connect it to the receiver instead.

Check to see that the 901 speakers are connected to the receiver MAIN or FRONT speaker jacks. In this way the 901 active equalizer signals will reach only the 901 speakers – the front channels of your home theater – and not any non-901 speakers used as center and surround channels.

Call Bose Corporation for assistance with the connection of additional speakers or signal

processing equipment. Refer to the address information inside the back cover of this guide.

A free booklet is available (USA only): Guide to Optional System Connections for Bose 901

Direct/Reflecting® Speaker Systems. Ask for part number 149393.

Figure 7

Home theater receiver connections

English

11

Image 12

Contents Page Bose 901 Series VI Direct/Reflecting Additional safety information For your recordsPlease read this owner’s guide Where to find… Warranty periodCustomer service Before you begin Unpacking the cartonsInstallation steps System CompatibilityChoosing the location for your speakers Choose the support for your speakersStep by step procedure for ceiling suspension Hardware needed for ceiling suspensionGeneral notes on ceiling suspension Choosing the wire Preparing the speaker wiresConnecting the speakers Speaker connectionsEqualizer Connections Checking the speaker connectionsStereo/non-home theater use Home theater use Home theater receiver connections Testing the speakers and equalizer To test the Tape Monitor connectionTo test the equalizer To test the PRE AMP OUT/MAIN AMP in connectionUsing other equipment To add a tape deck or VCRWhen connected to Tape Monitor When connected to PRE AMP OUT/MAIN AMPPlaying your speakers Adjusting the sound Using the MID-TREBLE and MID-BASS slidersUsing the Bass control Connecting additional speakers Equalizer compatibilityAdding 901 speakers Adding conventional speakersCleaning your speakers TroubleshootingProblem What to do Accessories Technical informationCanada European OfficeAustralia Belgique/BelgiëPage Bose 901 Series VI Direct/Reflecting Pour vos dossiers Autres consignes de sécuritéVeuillez lire la présente notice d’utilisation Service client Où trouver…Période de garantie Avant de commencer Ouverture du carton d’emballageMarche à suivre pour l’installation Compatibilité du systèmeDisposition des enceintes Instructions pour la dispositionChoix d’un support pour les enceintes Accessoires requis pour suspendre les enceintes Remarques générales pour suspendre les enceintesMarche à suivre pour suspendre les enceintes Connexion des enceintes Câbles appropriésPréparation des câbles Connexion des enceintesConnexion de l’égaliseur Vérification des connexions des enceintesUtilisation Stéréo/non home theater connexions Tape Monitor Utilisation home theater Connexions PRE AMP OUT/MAIN AMP Tape MonitorConnexion d’un récepteur de Home Cinema Vérification des enceintes et de l’égaliseur Vérification d’une connexion magnétophone Tape MonitorVérification d’une connexion PRE AMP OUT/MAIN AMP Utilisation d’autres équipements Ajout d’un magnétophone ou magnétoscopeÉcoute des enceintes Connexion à la prise Tape MonitorConnexion à la prise PRE AMP OUT/MAIN AMP Utilisation de la commande des Basses Réglage du sonRéglage des curseurs MID-TREBLE et MID-BASS Compatibilité de l’égaliseur Connexion d’enceintes supplémentairesEnceintes 901 supplémentaires Enceintes conventionnelles supplémentairesProblème Solution Nettoyage des enceintesDépannage Accessoires Informations techniquesUSA