English
Setting Up
3.Connect one end of a cable to the AMPLIFIER INPUT jacks on the 901® active equalizer.
a.Insert the first connector firmly into the INPUT jack marked R.
b.Insert the second connector into the INPUT jack marked L.
4.Connect the other end of the cable to the OUT or RECORD jacks on your receiver. These jacks may be marked TO INPUT, FROM INPUT, or REC.
a.Insert the first connector into the OUT or RECORD jack marked R.
b.Insert the second connector into the OUT or RECORD jack marked L.
5.Connect the second cable from the AMPLIFIER OUTPUT jacks on the 901 active equalizer to the IN or TAPE jacks on your receiver. These jacks may be marked PLAY, TO OUTPUT, FROM OUTPUT, or MONITOR.
6.Plug the power cord of the 901 active equalizer into one of the switched outlets on the receiver so that it will be powered when the receiver is switched on.
Figure 5
Connecting to the tape monitor connection
Home theater use
(PRE AMP OUT/MAIN AMP IN) Use these instructions:
• for
• if you are using a surround sound receiver that has a section on the back marked PRE AMP OUT/MAIN AMP IN. The jacks may be labeled ADAPTER or SIGNAL PROCESSOR.
Note: If your receiver does not have this PRE AMP OUT/MAIN AMP IN section, the 901 speakers will not be usable in your home theater system.
1. The PRE AMP OUT/MAIN AMP IN jacks on your receiver are usually connected by small bars called horseshoe pins. Remove these pins. See Figure 6.
Figure 6
Removing horseshoe pins | MAIN | PRE |
| AMP | AMP |
| IN | OUT |
L | L |
R | R |
Amplifier or Receiver
10