Maintaining Your 901®Series VI Speaker System
Cleaning your speakers
If your 901® speakers have a painted surface, clean with a soft damp cloth. If necessary, use a mild detergent such as dish soap. If the speakers have a wood veneer finish, clean them with wood furniture polish. You may vacuum the speaker grille panels carefully, if necessary.
Do not use any sprays near the system. Do not use any solvents, chemicals, or cleaning solutions containing alcohol, ammonia, or abrasives. Do not allow liquids to spill into any openings.
Troubleshooting
If you have a problem with your 901 Series VI speakers or 901 active equalizer, turn off the re- ceiver or amplifier before you proceed. Then check all the connections between the speakers, receiver, and active equalizer. Correct any wiring problems before you follow the guidelines below. Problems are more likely to originate with equipment other than speakers, so you may also want to refer to your receiver or other component owner’s guides.
English
Problem | What to do |
One speaker sounds | • Do not switch the wires; this could damage a speaker. Turn off the amplifier and disconnect |
defective, or does not play | the defective speaker wire at the amplifier. Reconnect it to the other channel. If the speaker |
| now plays correctly, the problem is not in the speaker or wiring. |
Neither speaker plays | • Connect the speakers to another receiver or amplifier that is known to be operating |
| properly. If the speakers now play correctly, the problem is not in the speakers. |
| Note that the tonal balance of the 901 speakers will be incorrect if the 901 active equalizer |
| is not being used with this second receiver or amplifier. |
The high and low | • Check to be certain that the 901 active equalizer is in the circuit. Review the Playing |
frequencies seem weak | your speakers section of this guide on page 14. |
You hear distortion | • Try turning down the volume. If the distortion goes away you may be using an insufficiently |
at high volume levels | powered receiver or amplifier. |
The trouble seems to be in | • Bypass the equalizer to see if the system operates properly without it. (Speakers will not |
the 901 active equalizer | have any highs or lows.) Check to see that all connections are correct and that none of |
| the cables is defective. |
Trouble persists in the | • Contact your authorized Bose® dealer to verify any defects and arrange for service by |
speakers or equalizer | a factory authorized agency or by the Bose factory. Bose Corporation will make every |
| effort to remedy any problem within the terms of the warranty. |
17