CARE AND CLEANING (continued)
CLEANING CYCLE PROCESS GUIDE
If cleaning is required, simply follow the steps below and refer to the Machine Cleaning Cycle Guide.
1.Use a cleaning tablet.
2.Insert the cleaning disk into the one or two cup filter basket.
3.Place the filter basket into the portafilter.
4.Pop 1 cleaning tablet into the filter.
5.Lock the portafilter into the group head.
6.Turn the machine ‘OFF’.
7.Simultaneously press and hold the one cup, two cup and the POWER button for 3 seconds.
8.The cleaning cycle will commence and last for approximately 5 minutes. Once complete, 3 beeps will sound. Remove the portafilter and ensure the tablet has completely dissolved.
If the tablet has not dissolved, repeat steps 5 to 7 until tablet has dissolved.
DECALCIFYING
After regular use, hard water can cause mineral build up in and on many of the inner functioning components, reducing the brewing flow, power of the machine, and affecting the quality of coffee.
We advise decalcifying the machine on a regular basis (every
Follow the instructions provided, or use the following as a guide:
Diluted solution (for softer water)
•1 part white vinegar
•2 parts cold tap water
Concentrated solution (for harder water)
•1 part white vinegar
•1 part cold tap water
WARNING: DO NOT IMMERSE POWER CORD, POWER PLUG OR APPLIANCE IN WATER OR ANY OTHER LIQUID.
THE WATER TANK SHOULD NEVER BE REMOVED OR COMPLETELY EMPTIED DURING DECALCIFYING.
DECALCIFYING THE MACHINE
•Remove the portafilter and frothing attachment. Pour the mixture of white vinegar and water into the water tank.
•Plug the machine into the power outlet and switch on.
•Press the POWER button to the ‘On’ position.
•Place a large container under the group head and steam wand.
•When the brewing temperature has been reached all the button surrounds on the Control Panel will illuminate. Press and hold
the one cup 
or two cup 
button to commence manual pour. Release the button once half the mixture of white vinegar and water has run through the group head.
•Set the steam dial to the ‘STEAM’ position and allow steam to run through the Steam Wand for approximately 2 minutes. Return the steam dial back to the ‘OFF’ position.
•After decalcifying, remove the water tank and rinse thoroughly then refill with fresh cold water. To rinse the machine, repeat previous steps.
47