Setting Oven Controls
Adjusting Oven Temperature
Your appliance has been factory calibrated and tested to ensure an accurate baking temperature. For the first few uses, follow your recipe times and temperature recommendations carefully. If you think the oven is cooking too hot or too cool for your recipe times, you may adjust the control so the oven cooks hotter or cooler than the oven temperature displayed.
The oven temperature may be increased as much as +35°F (+19°C) or decreased
Example — To increase (+) or decrease
1.Press and hold Bake keypad until the control provides the 2nd audible tone (about 6 seconds).
2.Enter 2 0 using numeric keypad.
3.Press Self Clean keypad to toggle between plus (+) if increasing temperature or minus
4.Press START to accept change.
Important notes:
•Oven temperature adjustments made will not change the Broil or Self Clean function temperatures.
•If the temperature shows an adjustment of
•DO NOT USE oven thermometers such as those found in grocery stores to check the temperature settings inside your oven. These oven thermometers may vary as much as 20 to 40°F degrees from actual temperatures.
•The oven temperature adjustment may be made if your oven control has been set to display °C (Celsius) temperatures. Maximum and minimum settings for Celsius are plus (+) or minus
Operating Oven Light
The interior oven light will automatically turn ON when the oven door is opened.
Press Oven Light to turn the interior oven light ON and OFF whenever the oven door is closed. Note that the oven light will not work during a Self Clean cycle.
The interior oven light is located at the upper left rear wall of the oven interior and is covered with a glass shield held by a wire holder. The glass shield protects the bulb from high temperatures and should always be in place whenever the oven is in use.
To replace the interior oven light, see Replacing oven light in the Care & Cleaning section.
Restoring Default Settings
Important note:
Restoring your default settings will reset all recipes and other adjustments to factory settings. These include 12 or
24hour display, continuous bake or
1.Press and hold the 7 keypad until the first single tone sounds (6 seconds).
2.After the first tone press START once.
Electrical outlet and circuit protection (on some models)
For protection against surcharge, a 15 amp, 110 volt circuit breaker reset is provided near the electric outlet located on top of backguard panel. If needed, press circuit breaker switch to reset.
22