Self Clean
As soon as Self Clean becomes active, a motor driven lock mechanism will begin locking the oven door automatically, and door Loc will appear in the display (See Fig. 1). DO NOT open the oven door when door Loc is displayed (allow 15 seconds for the lock mechanism to lock the oven).
Once the oven door has locked, CLn will appear in the display indicating Self Clean has started (Fig. 2).
Fig. 1 | Fig. 2 |
|
Fig. 3 | Fig. 4 |
When Self Clean is finished:
Use caution when opening the oven door after
1.CLn message will turn off and Hot will appear in display window (See Fig. 3).
2.Once the oven has cooled down (about 1 hour) and Hot is no longer displayed the door OPn message will appear (Fig. 4). When this message turns off the oven door may be opened.
3.When the oven interior has completely cooled, wipe away any residue or powdered ash with a damp cloth or paper towel.
Important notes:
•The kitchen area should be well ventilated using an open window, ventilation fan or exhaust hood during the 1st
•When the clean time finishes the oven door will remain locked until the range has cooled sufficiently. In addition to the clean time that was programmed, you must allow about 1 additional hour for the oven to cool before you will be able to open the oven door.
•The Self Clean function will not operate whenever a radiant surface element is ON or the Control Lock is active.
Delayed Start Self Clean
Example — To start a delay Self Clean with default clean time of 3 hours and a start time of 9:00 o’clock:
1.Be sure the clock is set with the correct time of day, the oven is empty and ALL oven racks are removed. Be sure oven door is completely closed.
2.Press Delay Start keypad.
3.Using numeric keypad enter 9 0 0 for time to start.
4.Press START to accept.
5.Press Self Clean keypad.
6.Press START.
If it is necessary to stop Self Clean when active:
1.Press OFF.
2.If Self Clean has heated the oven to a high temperature, allow enough time for the oven to cool and for the door OPn message to appear (Fig. 4). When this message turns OFF the oven door may be opened.
3.Restart Self Clean if needed.
Important notes:
•When Self Clean function is active you may check the amount of clean time remaining by pressing the Self Clean keypad once.
•If your control is set with the default 12 hour display mode, the Delay Self Clean can only be set to start up to 11 hours and 59 minutes in advance. To set a Delay Start Self Clean to begin 12 or more hours (maximum is 23 hours and 59 minutes) in advance, be sure to set the control for 24 hour display mode.
•If Self Clean is active and then interrupted by power failure or cancelled before the oven was thoroughly cleaned, it may be necessary to run a
27