KitchenAid KSCX 3610 manual Press OK to Install English, English Installed, Fill Tank

Page 12

501974402003_UK 8-10-2007 13:47 Pagina 12

4 Using for the first time

The first time you turn on the appliance and every time that it is plugged in, when you turn the main ON/OFF knob clockwise (A), the appliance makes a SELF-DIAGNOSIS operation and then turns itself off. To turn it on again, rotate the ON/OFF knob (2) clockwise on the control panel.

1.The first time you use the appliance, select the language.

Press the main ON/OFF switch on the rear side of the appliance; the lights on the front side and the display illuminate. Wait for the appliance to display:

PRESS OK TO INSTALL ENGLISH

Press the button for at least 3 seconds until the appliance displays:

ENGLISH INSTALLED

The appliance then displays the setting message in English.

2. After a few seconds, the appliance displays:

FILL TANK

To fill, remove the tank (fig. 1), rinse and fill with fresh water. Never exceed the MAX line. (When removing the tank, the cappuccino maker must always be positioned towards the centre of the appliance, otherwise the tank cannot be removed).

Put the tank back and push as far as it will go.

Move the cappuccino maker outwards (fig. 2) and place a cup underneath it.

3. The appliance now displays:

PRESS OK

Press the button. After a few seconds, a little water runs out of the cappuccino maker. When the cup contains about 30cc of water, the water stops running and it switches off.

4. The appliance now displays:

TURNING OFF PLEASE WAIT .. .

and it goes off.

5.Extract the appliance by pulling it outwards taking care to use the special handles, open the lid and the container with coffee beans (fig. 3), then close the lid and push the appliance inwards the appliance.

IMPORTANT: to prevent malfunction, never fill with ground coffee, freeze dried coffee, caramelised beans or anything else which could damage the appliance.

6. Turn the ON/OFF knob (fig. 4), The appliance displays:

HEATING UP PLEASE WAIT ...

to indicate that preheating is underway.

7. When preheating is complete, the appliance displays:

RINSING COMPLETE PLEASE WAIT ...

and performs an automatic rinse cycle (a little hot water runs out of the spouts and is collected in the drip tray beneath).

Tip: if you want to make a short coffee (less than 60 cc), to make it hotter, fill the cup with this hot rinsing water first. Leave it for a few seconds then empty it to warm the cup.

8. The appliance now displays the ready message:

READY STANDARD TASTE

12

Image 12
Contents Kscx 501974402003UK 8-10-2007 1347 Pagina 501974402003UK 8-10-2007 1347 Pagina Product description Product description Product description Control Panel Important notes Avoid exposing the appliance to atmospheric agentsBuilding-in Building-in Before first use Do not use multiple plug adapters or extension leadsPress OK to Install English English InstalledFill Tank Press OKPreparing coffee using coffee beans Empty Grounds Container Changing the quantity of coffee in the cup Regulating the coffee millReady PRE-GROUND Preparing cappuccinos using steam HOT Water Press OKHot water delivery Cleaning and maintenance Cleaning the coffee makerCleaning the infuser Correctly Correct Incorrect Start Time AUTO-START noDescale Descale noRinsing Fill Water Tank RinsingRinse Complete Press OK Button OFF After 1 HourReset to Default no Setting water hardnessResetting factory default settings Water HardnessMeaning of messages and what to do Message Meaning What to doProblem Cause Solution Ground coffee is being After-Sales Service Electrical connection for Great Britain and Ireland only501974402003UK 8-10-2007 1348 Pagina 5019 744