KitchenAid KSCX 3610 manual Correctly Correct Incorrect

Page 19

501974402003_UK 8-10-2007 13:48 Pagina 19

11 Cleaning and maintenance

Wash the infuser under running water, without using detergents. Never wash the infuser in the dishwasher;

clean the inside of the appliance thoroughly. To remove coffee encrustations from the inside of the appliance, scrape with a plastic or wooden fork (fig. 25) then vacuum up the residues with a vacuum cleaner (fig. 26);

replace the infuser by sliding it onto the supports and pin at the bottom, then push the PUSH symbol fully in until it clicks into place.

Support

Pin

Infuser

Push the PUSH symbol fully in until it clicks into place.

After having heard the click, check that the red buttons have snapped out.

Bottom pipe on the infuser.

The pin must be inserted into the bottom pipe on the infuser.

Check that the two red buttons have snapped out, otherwise the door cannot be closed.

The two red buttons

The two red buttons

have snapped out

have not snapped out

CORRECTLY

 

CORRECT INCORRECT

NOTE 1: If the infuser is not inserted correctly until it clicks into place and the two red buttons have not snapped out, the service door cannot be closed.

NOTE 2: If it is hard to insert the infuser, before inserting it squeeze it to the right size by pressing it forcefully from the top and bottom simultaneously, as shown in figure 27.

NOTE 3: If it is still hard to insert the infuser, leave it out of the appliance, close the service door, unplug from the mains then plug in again.

Wait for all the lights to go off, then open the door and replace the infuser.

replace the drip tray, complete with the grounds container;

close the service door.

19

Image 19
Contents Kscx 501974402003UK 8-10-2007 1347 Pagina 501974402003UK 8-10-2007 1347 Pagina Product description Product description Product description Control Panel Avoid exposing the appliance to atmospheric agents Important notesBuilding-in Building-in Do not use multiple plug adapters or extension leads Before first usePress OK Press OK to Install EnglishEnglish Installed Fill TankPreparing coffee using coffee beans Empty Grounds Container Regulating the coffee mill Changing the quantity of coffee in the cupReady PRE-GROUND HOT Water Press OK Preparing cappuccinos using steamHot water delivery Cleaning the coffee maker Cleaning and maintenanceCleaning the infuser Correctly Correct Incorrect Descale no Start TimeAUTO-START no DescaleOFF After 1 Hour Rinsing Fill Water TankRinsing Rinse Complete Press OK ButtonWater Hardness Reset to Default noSetting water hardness Resetting factory default settingsMessage Meaning What to do Meaning of messages and what to doProblem Cause Solution Ground coffee is being Electrical connection for Great Britain and Ireland only After-Sales Service501974402003UK 8-10-2007 1348 Pagina 5019 744