501974402003_UK
12 Changing and setting the menu parameters
12.6 Setting water hardness
The appliance is preset to display the descale message after a set period of time, based on a set water hardness. You can make descaling less frequent by programming the appliance based on the actual lime content in the water used. Proceed as follows:
•Remove the "Total Hardness Test" strip from its packaging then dip it fully in the water for a few seconds, Remove it and wait around 30 seconds (until it changes colour and a number of red dots are formed);
•Turn the appliance on by pressing the button (fig. 4).
• Press the | button then press the |
| button repeatedly until the appliance displays: |
WATER HARDNESS 4
•Press the button repeatedly until the number coincides with the number of red squares on the test strip (for example, if there are 3 red squares on the test strip, press the button until WATER HARDNESS 3 is displayed).
•Press the button to confirm the value. The coffee maker is now programmed to provide the descaling warning when necessary, based on the actual hardness of the water.
12.7 Resetting factory default settings
If you change the original values, the factory default values can be reset as follows:
• Press the , button then press the button repeatedly until the appliance displays:
RESET TO DEFAULT NO
•Press the button and the appliance displays “RESET TO DEFAULT YES”;
•Press the button to reset the factory default values;
• Press the | button to exit programming mode or | to change other parameters. |
13 Changing the language
To change the language, proceed as follows:
• Press the button for at least 5 seconds until the appliance displays:
PRESS OK TO INSTALL ENGLISH
and press the button for at least 3 seconds to confirm. The appliance then displays the setting message in English.
22