KitchenAid W10078153A Install the door handle on some models, Install door panel-Pro Line series

3.Add shims as needed in the area shown to bring dishwasher up to proper height.

NOTE: Shims must be securely attached to floor to prevent their movement when the dishwasher is operated.

2"

(5.1 cm)

shim shim

2-3/4"	6"	2-3/4"
	(15.2 cm)
(7.0 cm)		(7.0 cm)

Install the door handle (on some models)

IMPORTANT: Do not scratch the front panel during this procedure.

1.Remove the door handle and hardware bag containing the setscrews and Allen wrench from the cardboard box.

2.Start set screws in handle.

3.Place handle on mounting studs with the set screws facing down.

4.Push the door handle tightly against the door. Insert the short end of the Allen wrench into the setscrews. Tighten the setscrews 1/4 turn past snug. Retain Allen wrench with Installation Instructions.

mounting stud

handle

setscrew (in bottom of handle)

Allen wrench

Install the door handle—Pro Line® series

1.Remove the Pro Line® series handle and two screws from handle package.

2.Make sure plastic spacers are still attached to the door.

3. Attach the handle to the
factory-supplied full	plastic spacers
front panel as shown.

Install door panel—Pro Line® series

For top vented models with a factory-supplied stainless or painted full front panel:

1.Remove the carton containing the factory-supplied full front panel.

2.Remove the handle package from the front of the shipping base.

3.With a TORX® screwdriver, remove three screws on both sides, as shown; hold the outer panel up while removing the screws. Save screws for reinstallation.

4.Gently set outer panel aside.

3 screws

3 screws

outer panel

5.Lay the factory-supplied full front panel face down on a protective non-scratching surface.

6.Place the outer panel on the back of the full front panel; align screw holes.

7.Attach outer panel to full front panel panel with the four #10-16 x 3/8" hex head screws supplied in the literature package.

4 screws

hex head screw

full front panel

top edge

outer panel

8.Attach the panel assembly to the door by reinstalling the two uppermost side screws; do not tighten screws completely. This will hold the panel assembly in place on the door frame.

2 screws

factory-supplied full front panel

11