Attach Backguard or Island Trim

3-Wire Cable from Power Supply

IMPORTANT: Use the 3-wire cable from power supply where local codes permit connecting the frame-ground conductor to the neutral (white) junction box wire (not used for Canadian installations).

A. Cable from power supply	G. 4-wire flexible cable from
B. Junction box	range
C. Red wires	H. Black wires
D. White wire (from power supply)	I. UL listed wire nuts
E. Green (or bare) grounding wires	J. UL listed or CSA
(from range)	approved conduit
F. White wire (from range)	connector
F. White wire (from range)

1.Disconnect power.

2.Remove junction box cover if present.

3.Connect the 4-wire flexible cable from the range to the junction box using a UL listed or CSA approved conduit connector.

4.Tighten screws on conduit connector if present.

5.Connect the two black wires together using UL listed wire nuts.

6.Connect the two red wires together using UL listed wire nuts.

7.Connect the green (or bare) and white range cable wires to the white (neutral) wire in the junction box using UL listed wire nuts.

8.Install junction box cover.

9.Reconnect power.

WARNING

Excessive Weight Hazard

Use two or more people to move and install range. Failure to do so can result in back or other injury.

1.Using 2 or more people, move range close to cabinet opening.

2.Remove cardboard or hardboard from under range. Move range into its final position.

3.Attach the backguard or island trim as required for your installation. See “Tools and Parts.” Attachment screws are included in the literature package.

Attaching the Backguard

A. 3 front screws (4 rear screws required but not shown)

Attaching the Island Trim

A. Center hole not used

4.Using 2 or more people, tip the range back so that the front feet lift off the ground. Slide range toward the wall until the rear brace is under the anti-tip bracket. Stand range up, making sure the anti-tip bracket catches the rear brace.

Make Gas Connection

1.Assemble flexible connector from gas supply pipe to pressure regulator located in the middle front of the range.

2.Apply pipe-joint compound made for use with LP gas to the smaller thread ends of the flexible connector adapters (see B and G in following illustration).

3.Attach one adapter to the gas pressure regulator and the other adapter to the gas shutoff valve. Tighten both adapters.

4.Use a ¹⁵⁄₁₆" combination wrench and channel lock pliers to attach the flexible connector to the adapters. Check that connector is not kinked.

A B C

	H G	F
A. Gas pressure regulator	E. Manual gas shutoff valve
B. Use pipe-joint compound	F. ½" or ¾" gas pipe
C. Adapter (must have ½" male	G. Use pipe-joint compound
pipe thread)	H. Adapter
D. Flexible connector