If oven does not operate:
■Check that power supply is turned on.
■Check that the range is plugged in and the circuit breaker has not tripped or the household fuse has not blown.
Repeat
Complete Installation
1.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.
2.Check that range is correctly positioned in countertop cutout and that the range is level. See “Level Range.”
3.Check that the specified distances to cabinet surfaces were maintained. See “Location Requirements.”
Install Burner Grates
Place burner grates over burner caps. The simmer plate may sit on one of the grates or be stored for future use.
4.Check that burner caps are positioned properly on sealed burner bases.
5.Check that backguard or island trim is installed. (If horizontal clearance to combustible materials behind cooking surface is less than 1" [2.5 cm]).
Reinstall Bottom Vent
1.Insert lower vent tabs into the slots on the front trim.
2.Push vent upward until the holes line up at top of vent.
3.Reattach the vent using the 4 screws.
B
A
A.Bottom vent
B.Reattach these screws.
6.Check that the range is connected only to the type of gas for which it is certified for use.
7.Use a mild solution of liquid household cleaner and warm water to remove waxy residue caused by protective shipping material. Dry thoroughly with a soft cloth. For more information, see the “Range Care” section of the Use and Care Guide.
8.Read “Range Use” in the Use and Care Guide.
9.Turn on surface burners and oven. See the Use and Care Guide for specific instruction on range operation.
If range does not operate, check the following:
■Household fuse has not blown, or circuit breaker has not tripped.
■Gas valves are turned to the “ON” position.
■If the gas supply line shutoff valve is open, contact a qualified technician.
■Electrical supply is connected.
■See “Troubleshooting” in the Use and Care Guide.
WIRING DIAGRAMS
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
Cooktop Schematic
L1 |
|
| N L2 |
|
|
| R |
|
| W | W |
|
|
| |
| GND | W | W |
|
|
| |
R | GR | W |
|
|
| SPARK |
|
|
| MODULE |
|
VALVE SWITCHES
Y OR BR (6) PLCS
IGNITER ELECTRODES
12