|
|
|
|
|
| Installation |
|
|
|
|
|
| WARNING – THIS APPLIANCE MUST BE EARTHED. |
|
|
|
|
|
| Your cooker should have been checked to ensure that the |
|
|
|
|
|
| |
|
|
|
|
|
| voltage corresponds with your supply voltage, this is stated |
|
|
|
|
|
| on the rating plate, which is situated on the rear panel. |
|
|
|
|
|
| The cooker must be connected by a competent |
|
|
|
|
|
| person eg. (NICEIC registered contractor) to suitable |
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
| and a minimum contact clearance of 3mm, which should |
|
|
|
|
|
| be fitted adjacent to the cooker, in accordance with IEE |
|
|
|
|
|
| |
|
|
|
|
|
| regulations. |
|
|
| ||||
|
|
|
|
|
| The power supply cable should conform to B.S.6004 with a |
|
|
|
|
|
| |
|
|
|
|
|
| |
|
|
|
|
|
| conductor size of 6mm2 minimum. |
|
|
|
|
|
| The control unit should be easily accessible in the event of |
|
|
|
|
|
| an emergency, but must be within 2 metres of and not |
|
|
|
|
|
| directly above an appliance. |
|
|
|
|
|
| This appliance conforms to EN 55014 regarding |
|
|
|
|
|
| suppression of radio and television interference. |
|
|
|
|
|
| Access to the mains terminals is gained by removing the |
|
|
|
|
|
| |
|
|
|
|
|
| rear access cover. |
|
|
|
|
|
| |
|
|
|
|
|
| The mains cable must pass through the cable clamp |
|
|
|
|
|
| adjacent to the terminal block. Sufficient cable should be |
|
|
|
|
|
| used to allow the cooker to be pulled out for servicing. |
|
|
|
|
|
| Ensure that the mains cable is routed away from any |
|
|
|
|
|
| brackets affixed to the rear panel and is not trapped to the |
|
|
|
|
|
| rear wall when pushing the cooker into position between |
|
|
|
|
|
| cabinets. |
Siting the Cooker |
|
|
| The cooker is designed to fit between kitchen | ||
|
|
|
|
|
| cabinets spaced 500mm apart. The space either side need |
|
|
|
|
|
| only be sufficient to allow withdrawal of the cooker for |
|
|
|
|
|
| servicing. It can be used with cabinets one side or both |
|
|
|
|
|
| as well as in an angled corner setting. It can also be used |
|
|
|
|
|
| free standing. |
This cooker is a Type X appliance, as such adjacent side walls which project above hob level, must not be nearer to the cooker than 150mm and should be protected by heat resistant material. Any overhanging surface or cooker hood should not be nearer than 650mm.
The height of the cooker can be adjusted by means of adjustable feet in the plinth (900mm - 915mm). Adjust the feet by tilting the cooker from the side. Then install the cooker into position.
5