Hotpoint CH60EKWS, CH60 EKS Installation, Mains Connection, Siting the Cooker, Moving the Cooker

Page 5

INSTALLATION

WARNING - THIS APPLIANCE MUST BE EARTHED.

Mains Connection

Your cooker should have been checked to ensure that the voltage corresponds with your supply voltage, this is stated on the rating plate, which is situated on the outer rear panel.

The model number and serial number are located on the front of the cooker, as shown on the Feature's page. The cooker must be connected by a competent person such as one who is a, NICEIC registered contractor to a suitable double-pole control unit with a minimum rating of 32A and a minimum contact clearance of 3mm (applicable to newer properties, older properties where a 30A double pole control unit and a minimum contact clearance of 3mm is acceptable).

The double pole control unit should be fitted adjacent to the cooker, in accordance with IEE regulations. The control unit must be within 2 metres of but not directly above the appliance and should be easily accessible in the event of an emergency.

The power supply cable should conform to B.S.6004 with a conductor size of 6mm2, minimum.

Access to the mains terminals is gained by removing the rear access cover. The mains cable must pass through the cable clamp adjacent to the terminal block. Sufficient cable should be used to allow the cooker to be pulled out for servicing.

Ensure that the mains cable is routed away from any brackets affixed to the rear panel and is not trapped to the rear wall when pushing the cooker into position between cabinets.

Levelling

Four feet are fitted which can be adjusted up or down to set the height (900mm - 930mm) and level the cooker. The feet can be simply screwed in or out to lower or raise the cooker.

After the correct height is achieved, lock the feet into position by tightening the locking nut using an open ended spanner.

CAUTION: Some soft floor coverings may get damaged if the cooker is not moved carefully.

NOTE: Ensure oven shelves are level by using a spirit level on the rod shelves.

Siting the Cooker

The cooker is designed to fit between kitchen cabinets spaced 600mm apart. The space either side need only be sufficient to allow withdrawal of the cooker for servicing and cleaning.

It can be used with cabinets one side or both as well as in an angled corner setting. It can also be used freestanding.

Adjacent side walls which project above hob level, must not be nearer to the cooker than 150mm and should be protected by heat resistant material. Any overhanging surface or cooker hood should not be nearer than 650mm.

Note: This appliance must NOT be fitted on a platform.

Moving the Cooker

Before moving your cooker, switch off at the cooker control unit, ensure that it is cool.

Open the grill door sufficiently to allow a comfortable grip on the underside front edge of the oven roof, avoiding any grill elements.

Radio Interference

This appliance conforms to EN 55014 regarding suppression of radio and television interference.

Note: Take care in moving the cooker as it is heavy. Take care to ensure that any floor covering is not damaged.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

5

Image 5
Contents Use and Installation Instructions Very HOT Surfaces Contents Main Oven Usable Volume 71 Litres Top Oven Usable Volume 36 LitresIntroduction HobMains Connection InstallationSiting the Cooker Moving the CookerAlways Safety InformationPans Unattended While Cooking Safety Advice in Case of a CHIP-PAN FireAreas can Become HOT FeaturesRight Front Control ControlsHotplate Controls Grill Control-Top Oven Slow Setting STop Oven Control Main Oven ControlHints on Automatic Cooking Oven Timer OperationClockface Know Your TimerSymbols Setting the Time of DAY Electronic Clock & Automatic Oven Timer OperationAuto Cooking Programmes U1 6 2 Other Notes on Timer Operation Condensation Temperature Conversion ChartTemperatures Never USE Using Ceramic HOBAlways USE Do Not Care Ceramic HOBSafety requirements for deep fat frying High Speed Grill Grilling procedureKept away Grilling should not be Undertaken with the GRILL/TOP OvenGrill pan handle Guide to grilling successfullyTo use the oven proceed as follows TOP Oven Conventional CookingDo not place food or dishes on the floor of the oven Platewarming in the top ovenMain Oven FAN Cooking Slow setting Using the Slow Cook Setting SPoints to consider when preparing food for Slow cooking Storage and re-heating of foodTemperature C Time in mins Position in Oven Oven Temperature Charts BakingBeef Oven Temperature Charts MeatLamb 80C Poultry Pork 90CCleaning of the Ceramic Hob Care and CleaningOven Door Cleaning Stay Clean LinersOven Fittings Oven InteriorsDoor and Control Panel Glass Replacement of the Oven LightHigh Speed Grill Do not use the oven lamp as/ for ambient lightingSide Opening Doors Cleaning the DoorsDrop Down Doors Remove the door inner glass as followsSomething Wrong With Your Cooker Problem CheckSomething Wrong Disposal of old electrical appliances Disposal of your productGuarantee After Sales Service

CH60 EKS, CH60EKKS, CH60EKWS specifications

The Hotpoint CH60EKWS, CH60EKKS, and CH60 EKS are versatile and stylish double oven cookers designed to elevate your cooking experience in the modern kitchen. These cookers combine practicality with advanced cooking technologies, making them ideal for both everyday meals and special occasions.

One of the standout features of the Hotpoint CH60 series is its dual ovens. With a main fan-assisted oven and a top conventional oven, users have the flexibility to cook different dishes at varying temperatures simultaneously. The fan-assisted oven ensures even heat distribution, allowing for perfectly baked pastries and roasted meats. The secondary oven is ideal for dishes that require gentler heat or when using multiple cooking methods.

Another key characteristic of these models is their energy efficiency. They are designed with the environment in mind, featuring an A energy rating, which not only helps reduce energy consumption but also lowers utility bills. This efficiency does not compromise performance; instead, it ensures that users can enjoy high-quality cooking while being mindful of their energy usage.

The CH60 series also showcases a sleek and contemporary design that seamlessly fits into any kitchen aesthetic. With clean lines and a polished finish, the cookers are easy to clean and maintain. Many models include a ceramic glass hob, which not only adds to the aesthetic appeal but also simplifies the cleaning process. The hob heats up quickly and evenly, allowing for rapid cooking.

For safety and convenience, these cookers come equipped with features such as flame failure devices, ensuring that gas supply is cut off if the flame goes out. Additionally, the integrated timer and programmable functions allow users to plan their cooking activities with precision, providing an added layer of ease.

Hotpoint has also incorporated innovative technologies like the "Easy Clean" oven interior, which features a special coating that aids in reducing cleaning time. This technology makes maintenance effortless, ensuring that the ovens remain in pristine condition for years to come.

Overall, the Hotpoint CH60EKWS, CH60EKKS, and CH60 EKS offer a combination of functionality, energy efficiency, and style. They cater to a variety of cooking needs, making them an excellent choice for families who enjoy cooking together and want reliable performance in their kitchen. With their thoughtful features and user-friendly design, these cookers are indeed a valuable addition to any culinary space.