Save These Instructions, Grounding Instructions

13.To avoid injury, never place blade assembly on the base without container properly attached.

14.Always operate blender with cover in place.

15.When blending hot liquids, remove center piece of two-piece cover. Begin processing with only one cup (8 oz.). Always begin processing at the lowest speed setting. Keep hands and other exposed skin away from the lid opening to prevent possible burns. See Hot Blending instructions, next page.

16.Screw on container bottom firmly. Injury can result if moving blades accidentally become exposed.

17.Do not leave blender unattended while it is running.

18.Do not operate your appliance in an appliance garage or under a wall cabinet. When storing in an appliance garage, always unplug the unit from the electrical outlet. Not doing so could create a risk of fire, especially if the appliance touches the walls of the garage or the door touches the unit as it closes.

SAVE THESE INSTRUCTIONS

Grounding Instructions

For your protection, Waring Pro® Blenders are equipped with a 3-conductor cordset that has a molded 3-prong grounding-type plug, and should be used in combination with a properly connected grounding-type outlet as shown in Figure 1. If a grounding-type outlet is not available, an adapter, shown in Figure 2, may be obtained so that a 2-slot wall outlet can

be used with a 3-prong plug. Referring to Figure 3, the adapter must be grounded by attaching its grounding lug under the screw of the outlet cover plate. CAUTION: Before using an

adapter, it must be determined that the outlet cover plate screw is properly grounded. If in doubt, consult a licensed electrician. Never use an adapter unless you are sure it is properly grounded.

Note: Use of an adapter is not permitted in Canada.

This appliance is for 120 volts only and should not be used with a converter.

Important: Hot Blending Instructions

To minimize possibility of scalding when blending hot ingredients, the following precautions and procedures must be observed:

1.Limit amount of material processed to one cup (8 oz.).

2.Completely remove the lid insert of the two-piece container lid before starting motor. (This will allow venting of the rapidly heated and expanding air present inside container when blender is running.)

3.Start blending on low speed.

4.While blender is running, up to 1½ cups (12 oz.) of additional liquid can be added. Pour liquid slowly through the opening in the lid.

Operating Instructions

1.When placing the container on the unit base, make sure that the unit is turned off and is at a complete stop. Do not put the container on or take it off while the unit is running. Doing so may damage the drive shaft or blade assembly. For best results, do not fill container above

3-cup level.

2.Be sure the switch is in the off position and plug the blender into a convenient outlet.

3.The Waring Pro® Blender is ideal for blending ice drinks. A hint when mixing ice drinks: keep the blades in the container covered with liquid, turn the unit on, remove the lid insert on top of the jar lid, and feed the ice cubes slowly into the jar. NOTE: Never use containers other than Waring Pro® Blender containers with your Waring unit.