Bifinett KH 150 manual Safety / Before the First Usage / Operation, First steps, Working advice

Safety / Before the First Usage / Operation

ance repaired at an authorised service centre	j	Push the food holder plate			11	on to the food
or by an other suitably qualified specialist.		carriage.
J Use the appliance with the supplied accesso-	j	Place the catch tray	17	below the support
ries only.		table and on the housing such that the sliced
No claims under the warranty nor a liability for		foods can fall in there directly and without
damages will be accepted if they result from		hindrance after being cut.
improper or incorrect use of the slicer.

QBefore the First Usage

QFirst steps

jCarefully remove the slicer from its packaging, remove all packaging materials and keep them together with the main packaging.

jClean the slicer before it comes into contact with any foodstuffs (see also the chapter ‘Cleaning’).

QSetting up the appliance

Specific safety advice on the placing of the appliance

1.Never set the slicer up on a hot surface or near an open flame.

2.Ensure that the power cable does not pass over hot or sharp-edged objects.

3.Do not allow the power cable to become kinked or trapped and do not wrap it around the slicer.

jSet the slicer up on a flat, non-slip surface close to a power socket.

jUnwind the required length of power cable 8 . Insert the plug into the power socket.

jPlace the food carriage 10 on the supporting table with guide slot 9 . Now press the on the blade cover 6 high standing side down, so that the holding clamps (on the underside of the food carriage 10) engage. Ensure that these have correctly engaged, in that you check the mobility of the food carriage.

Pull to the front for removal of the food carriage 10 from the guide slot 9 and lift it from the support table.

8 GB

QAdjust the infinite slice-thick- ness setting (see Fig. D)

Through variable tightenings of the adjusting screws 16 you can determine the movement rate of the infinite slice-thickness setting 14.

jScrew both of the adjusting screws 16 tight with the screwdriver 15.

jCheck, by turning the infinite slice-thickness control knob 14, to see if the desired movement rate is suitable.

If it is not,

-loosen both adjusting screws 16 for a lighter movement rate or

-tighten both adjusting screws 16 further for a stiffer movement rate.

QOperation

QWorking advice

Specific safety advice for slicing and for the handling of the appliance

1.Never touch the blade when the slicer is in operation!

There is a risk of grave personal injury!

2.Always use the food carriage 10 and the food holder plate 11.

(Exception: very large pieces of foodstuff). Press the pieces of food to be sliced forward using the food holder 11.

3.Use the slicer only for cutting normal house- hold foods and not for other purposes. Do not use the slicer for cutting deep-frozen foods, bones, foods with large kernels or for the slicing of still packaged foods.