6.Connect the power supply ground wire to the green ground connector and tighten securely.
A
A. Green ground connector
7.Securely tighten the strain relief.
8.Replace the wiring cover.
UL-Listed Power Supply Cord Kit (U.S. Only)
1.Connect a
2.Replace the wiring cover.
Install Range Hood
WARNING
Excessive Weight Hazard
Use two or more people to move and install range hood. Failure to do so can result in back or other injury.
1.Remove the 4 hood mounting screws from the parts bag and install in previously drilled ¹⁄₈" (3.0 mm) pilot holes. Leave screw heads about ¹⁄₄" (6.4 mm) away from shim strips.
¹⁄₄" (6.4 mm)
2.Lift range hood into final position, feeding electrical wire through wiring opening. To avoid damage, do not push on fan blade.
3.Position the range hood so that the large end of the keyhole slots are over the screws. Then push the hood toward the wall so that the screws are in the neck of the slots.
A
B
A
A. Keyhole slots (4)
B. Mounting screw
4.Tighten mounting screws to cabinet, making sure mounting screws are in narrow neck of slots.
On vented installations:
5.Make sure that damper blade opens and closes freely.
6.Connect ventwork to hood. Seal joints with duct tape to make them secure and air tight.
Complete Installation
1.Install (2) PAR20, 50W maximum halogen bulbs or (2) R16, 40W maximum incandescent bulbs. Bulbs purchased separately.
2.Replace filters.
NOTE: Filter slot must be toward front of hood.
For
3.Reconnect power.
4.Check for proper operation.
9