Whirlpool GZ5736XR, GZ5730XR For non-vented installations, For vented installations

2.Remove tape holding standard filters in place. Remove both filters. Insert flat blade screwdriver into slots in filters. Push each filter toward back of hood, lift out and set aside.

A

B

A. Filter slots

B. Flat blade screwdriver

3.Remove damper/vent connector from inside the hood. Set connector, mounting screws and parts bag aside.

A

A. Damper/vent connector

4.Remove wiring cover from inside the hood. Set cover and mounting screw aside.

A

A. Wiring cover

5.Depending on your installation, remove either top or back wiring knockout and install a ¹⁄₂" UL- or CSA-listed strain relief.

A

A. Strain relief

For non-vented installations

Go to “Make Electrical Connection” section.

For vented installations

1.Remove the five screws holding the light panel in place and set them aside.

2.Disconnect the light assembly wiring connector. Make sure not to disconnect any wires.

3.Remove the light panel and set aside.

A

A. Light panel

4.Remove the air chute held in place with one screw.

A

A. Air chute

5.Remove baffle from air chute.

A

A.Baffle

6.Rotate baffle and reinsert it back into the air chute so that the baffle tabs fit all the way into the slots in the air baffle.This will close off the air flow through the non-vented slots on top of the hood.

A

B

A. Tab slots

B. Tabs

7.Replace air chute.

8.Connect light assembly wiring connector and replace light panel.

NOTE: Make sure not to trap wires between the support fin and light panel.

7