Hobart HFB12 ML-114906 Removing and Installing the TOP Lamp Shield, Oven Door Lamp Shield Rail

Page 20

10.Clean the inside of the oven door window with a cloth dampened with window cleaner. If necessary, use a nylon scouring pad to remove baked on grease. Wipe the window clean with a cloth or paper towel dampened with window cleaner. CAUTION: Do not use abrasives on the reflective inside door surface.

11.With a clean cloth dampened with a food quality sanitizer, wipe the entire interior cavity of the oven, working from the back forward.

12.Clean the exterior of the oven with a soft cloth dampened sparingly with a commercial stainless steel cleaner. The outside of the oven door window may be cleaned with a cloth dampened with window cleaner.

13.NEVER touch the cooking lamps. Skin oils on the lamps will lead to premature lamp failure. If contact does occur, gently wipe the lamps with a clean, lint-free cloth dampened with rubbing alcohol.

REMOVING AND INSTALLING THE TOP LAMP SHIELD

Turn the oven off before removing the lamp shield.

The lamp shields MUST be kept clean to ensure maximum efficiency of the oven. If the lamp shields are dirty, foods may not cook as quickly or as thoroughly as specified in the programmed recipes. The lamp shields should be cleaned anytime food or grease begins to build up on the shield surface. Keeping the shields clean will prevent residue from baking on the shields and burning.

The upper lamp shield is easily removed with the door open. Lift the front edge of the lamp shield over the retaining feature (Fig. 5) and pull it toward you.

To reinstall the lamp shield, place it on its rails and gently push it into the oven until it stops. Be sure the lamp shield is properly seated behind the retaining feature.

OVEN DOOR

LAMP SHIELD RAIL

LIFT LAMP SHIELD

UPPER LAMP SHIELD

OVER RETAINING FEATURE

LOWER LAMP SHIELD

PULL LAMP SHIELD TOWARD YOU

(NON REMOVABLE)

 

PL-52646

Fig. 5

It is recommended that you keep spare lamp shields so that dirty ones can be replaced quickly. Dirty shields can then be cleaned during off-peak times.

The lamp shield is made of a special transparent material with specific properties. Replace shield only with official FlashBake oven replacements.

– 20 –

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Tion Table of Contents Location InstallationUnpacking Installation Codes and Standards AssemblyExhaust Duct Installation United States of AmericaFor Hard-Wired Ovens For a Single-Phase 240 Volt OvenElectrical Connections For Cord-Connected OvensLamp Test START-UP TestingElectrical Data Voltage Test Empty RecipePrecautions OperationUtensils to USE Approved Never UseProgramming the HFB12 Flashbake Oven To Create or Edit a RecipeRecipe Options and Limits To Save a Recipe or Exit Programming ModeLamp Center and Outer Power Levels Fig Creating a Standard Cook Method Recipe Lamp Power Cook TimeCreating a TWO-STEP Cook Method Recipe Full Power TmeStandard Recipe Display Zone Power TimeTwo-Step Recipe Display Operating the HFB12 OvenExtending the Cook Time Stopping or Pausing a RecipeStarting a Recipe Cooking Hints High THROUGH-PUT Volume ConsistencyCook Cycle Counter Blower Setting Food TypeCleaning Approved Cleaning Materials and Procedures Cleaners Cleaning ToolsRemoving and Installing the TOP Lamp Shield Oven Door Lamp Shield RailMaintenance Lamp ReplacementInspecting the Oven FusesTroubleshooting Problem Possible CausesHigh Power is not on Message Action
Top Page Image Contents