Hobart HFB12 ML-114906 manual Installation Codes and Standards, United States of America, Canada

Page 4

There must be a 3" (76 mm) clearance on each side of the oven. The area behind the oven around the blower must be kept clear of obstructions and allow for free air circulation.

If your oven is equipped with the power cord and plug, ensure that the cord can be plugged into the appropriate outlet.

INSTALLATION CODES AND STANDARDS

The HFB12 FlashBake oven must be installed in accordance with:

In the United States of America:

1.State and local codes.

2.National Electrical Code, ANSI/NFPA-70 (latest edition). Copies may be obtained from The National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.

In Canada:

1.Local codes.

2.Canadian Electrical Code, Part 2, CSA Standard C22.1 (latest edition). Copies may be obtained from The Canadian Standard Association, 178 Rexdale Blvd., Rexdale, Ontario, Canada M9W 1R3.

ASSEMBLY

Install the upper lamp shield into the oven cavity. Be sure the shield is pushed all the way back and is lying flat in the channels. Refer to REMOVING AND INSTALLING THE TOP LAMP SHIELD in this manual.

Place the grill on the rollers.

EXHAUST DUCT INSTALLATION

A length of flexible exhaust duct may be attached to the oven to vent hot air out of the cooking area. Attach the duct to the blower assembly (Fig. 1).

Flexible Duct

(By Others)

Fan

Electrical

Duct Clamp (By Others)

Junction Box

or

Power Cord AssemblyBlower

(If Applicable)

OVEN REAR

Fig. 1

PL-52643

– 4 –

Image 4
Contents Tion Table of Contents Unpacking InstallationLocation Installation Codes and Standards AssemblyExhaust Duct Installation United States of AmericaFor Hard-Wired Ovens For a Single-Phase 240 Volt OvenElectrical Connections For Cord-Connected OvensElectrical Data START-UP TestingLamp Test Voltage Test Empty RecipePrecautions OperationUtensils to USE Approved Never UseProgramming the HFB12 Flashbake Oven To Create or Edit a RecipeLamp Center and Outer Power Levels Fig To Save a Recipe or Exit Programming ModeRecipe Options and Limits Creating a Standard Cook Method Recipe Lamp Power Cook TimeStandard Recipe Display Full Power TmeCreating a TWO-STEP Cook Method Recipe Zone Power TimeTwo-Step Recipe Display Operating the HFB12 OvenStarting a Recipe Stopping or Pausing a RecipeExtending the Cook Time Cook Cycle Counter High THROUGH-PUT Volume ConsistencyCooking Hints Cleaning Setting Food TypeBlower Approved Cleaning Materials and Procedures Cleaners Cleaning ToolsRemoving and Installing the TOP Lamp Shield Oven Door Lamp Shield RailMaintenance Lamp ReplacementInspecting the Oven FusesTroubleshooting Problem Possible CausesHigh Power is not on Message Action