Jenn-Air W10379137A manual Location Requirements, Opening Dimensions, Model Width a Dimension B

Location Requirements

■ The water shutoff should be located in the base cabinet on

WARNINGeither side of the refrigerator or some other easily accessible area. If the water shutoff valve is not in the cabinets, the

plumbing for the water line can come through the floor. See “Water Supply Requirements” for more information.

Explosion Hazard
Keep flammable materials and vapors, such as		80" - 90"
gasoline, away from refrigerator.		(203-229 cm)		B
Failure to do so can result in death, explosion, or fire.				Dimension
IMPORTANT:
■ Observe all governing codes and ordinances.
■ It is recommended that you do not install the refrigerator near		84" (213.4 cm)
an oven, radiator, or other heat source.		to bottom of solid soffit
■ Do not install in a location where the temperature will fall
below 55°F (13°C).
■ Floor must support the refrigerator weight, more than 600 lbs
(272 kg), door panels and contents of the refrigerator.				77"
■ Ceiling height must allow for side tipping radius. See “Tipping				(196 cm)
Radius.”
■ Location should permit door to open fully. See “Door Swing			A
Dimensions.”
■ Location must permit top grille removal. See “Opening			Width
		(see chart following)
Dimensions.”
Opening Dimensions
■ The width of the opening, from side to side, must be as
specified for your model, for at least 2" (5.08 cm) back from
the face of the cabinet.
NOTE: If your opening does not meet this requirement, you
will need to make modifications.
■ A solid soffit or wall cabinet must be installed 84" (213.4 cm)
above the floor. If the solid soffit is higher than 84" (213.4 cm)		C	1"
or one is not available, then the refrigerator must be braced.		6"	(2.54 cm)	6"
If the anti-tip boards are needed, they must be attached to the		(15.2 cm)		(15.2 cm)
rear wall studs so that there is 84" (213.4 cm) from the bottom
of the anti-tip board to the floor. See “Install Anti-Tip Boards”
for more information.	Model	Width A		Dimension B
■ For a fully integrated installation, a minimum of 6" (15.24 cm)		(as shown above)		(as shown above)
of open space above the refrigerator is required. See “Fully	36	36" (91.4 cm)		4" (10.2 cm)
Integrated Installation.” Anti-tip boards are required. See
	42	42" (106.7 cm)		10" (25.4 cm)
“Install Anti-Tip Boards” for more information.
■ A grounded 3 prong electrical outlet should be located within
a specified number of inches from the right-hand side	Installation Type		Depth C (as shown above)
cabinets or end panel. See the chart following the graphic for	Standard Flush		25" (63.5 cm) minimum
the number of inches required for your model. For more
information, see “Electrical Requirements.”	(new installation)
	Retrofit Installations		24" (60.9 cm) minimum
	IMPORTANT:
	■ The width of the opening (Width A), must be as specified
	for your model, for at least 2" (5.08 cm) back from the face
	of the cabinet.
	NOTE: If your opening does not meet this requirement,
	you will need to make modifications.
	■ Flooring under refrigerator must be at same level as the
	room. Face of cabinetry must be plumb.

9