Oven Racks
To remove, pul! forward to the "stop" position; lift up on the front of the rack and pull out.
Oven Thermostat Knob Adjustment
The oven thermostat knob can be adjusted if the oven temperature is too low or
too high and the length of time to cook ALL foods is too long or too short. Do NOT adjust the thermostat knob if only one or two items are not baking properly.
To adjust the thermostat knob:
Turn the oven thermostat knob to OFF.
Remove the knob and turn it to the under- neath side. Hold it so that the triangle is
_Triangle
at the | top. | (See | Fig. | 1)Loosen | the | two | w/_,J_°o__S. '_[/'_j_,.cf/2 | ||||||||||
move the | top | screw | by | rotating | the | knob |
| o | _ | o | /_ | ||||||
screws | slightly. | Holding |
| the | skirt | in | place, | II | _ | E | _ " | ||||||
onenotch, | asnotedbyoneclick, | indirection | _ | _((_)_ | . | II | |||||||||||
necessary. |
| If | notch | indentation |
| is | not | _k\ | %_ _ | ,_ //_'skirt | |||||||
apparent, tighten screws until clicking | is | _ "__ | _ |
| /n | ||||||||||||
heard. | There | are |
| five |
| notches | in | each | __ |
|
|
|
| ||||
direction. | One | notch | equals | approximately |
| FIG. 1 | |||||||||||
IO°F. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| cool | and |
| ALL | foods |
| are |
|
|
|
|
| |||
|
|
| requiring | a longer time | period |
|
| _s_ |
|
| |||||||
|
|
| to cook, the knob should | be |
| _ |
|
| |||||||||
|
|
| rotated |
| to move | the | top | screw |
| ,_ _ | _o |
| |||||
|
|
| toward the word "HOTTER" |
| _ | _ | o |
| |||||||||
Tighten | the | screws | while tightly | holding | \\ |
| _o_,_o_ | / | |||||||||
Y_,MPLE: If | the | oven | temperature | is | too | /(k\.______(_'_°_ |
| ||||||||||
knob to skirt. | To | replace | knob, | match | flat |
|
|
|
|
| |||||||
part of | knob | opening | with | spring on | the |
|
|
|
| FIG. 2 |
shaft, returning to OFF position.
IMPORTANT: The oven thermostat knob should be adjusted one notch and then the oven should be tested. (We recommend baking 2
If the knob is rotated too far or in the wrong direction, rotate the knob in the opposite direction until the center of the screw is directly under the triangle, which is the
starting point. Initiate the procedure again until the desired temperature is reached.
47