AEG CG 6400 manual Running the descaling program, Upper line of the display shows, «50%»

Page 26
25%».
5%».

g

3If it is still hard to insert the brewing unit, leave it out of the appliance, close the service door, unplug the appliance from the mains, then plug in again.

Wait unitl the display has switched off, then open the service door and replace the brewing unit.

14.5Running the descaling program

The descaling program allows you to descale your coffee machine simply and effectively. The coffee machine must be descaled when you are

instructed to do so by the display showing the message «DESCALE».

1Important: Do not under any circum- stances use any descalers which are not recommended by AEG/Electrolux. If other descaling agents are used, AEG/ Electrolux accepts no liability for any damage. You can obtain descaling liq- uid from specialist retailers or from the AEG/Electrolux Service Line.

3The descaling process takes about

45 minutes and should not be inter- rupted. In the event of a power failure or interruption, the program must be restarted!

0Before starting the descaling program, clean the brewing unit (refer to „Cleaning the brewing unit“, page 51).

0Press the "Menu" key (Fig. 4). The menu item «CHOOSE LANGUAGE» appears.

0Press the scrolling keys "<" or ">" (Fig.

5)until the menu item «DESCALE» appears.

0Confirm the menu item with the "OK"

key (Fig. 5). The display shows «DESCALE NO».

0Press the scrolling key "<", and the dis- play shows «DESCALE YES».

0Confirm with the "OK" key (Fig. 5). The descaling program is started.

3If "OK" is not pressed, after about

120 sec. the appliance returns auto- matically to the coffee mode and the descaling program will not be started.

The upper line of the display shows the

alternating messages «ADD DESCA- LER» and «TURN STEAM KNOB»,

whilst the lower line shows an advan- cing progress bar with a percentage indication, e.g.

«

0Empty the water tank, fill the tank with at least 1 liter of water and add the descaling agent.

1Note: Make sure descaling agent is splashed onto surfaces sensitive to acid such as marble, limestone and ceramics.

0Place a container with a minimum capacity of 1.5 litres under the steam nozzle (Fig. 9).

0Turn the knob for steam and hot water

to the position .

The descaling program starts and the descaling solution runs out of the

steam nozzle. The display shows

«DESCALING» and an advancing progress bar with a percentage indica- tion, e.g.

«

The descaling programme automati- cally performs a series of flushes and pauses to remove limescale deposits from inside the coffee maker.

After approx. 45 minutes, the water tank will be empty and the upper line

of the display will show the alternating messages «DESCALE COMPLETE» and «TURN STEAM KNOB», whilst

the lower line shows a progress bar with the percentage indication

«

50%».

0Turn the knob for steam and hot water back to the position .

The machine is now ready to be rinsed with fresh water. The upper line of the

display shows the alternating messages «RINSING» and «FILL TANK», whilst the lower line shows a progress bar with the percentage indication

«50%».

0Remove the water tank and fill it with fresh water and then replace it in the

52

Page 25 Page 27
Image 26
Page 25 Page 27
Contents Kaffee-Espresso-Vollautomat Fully Automatic Espresso Maker Page Page Page Page Page Dear Customer Contents Control panel Fig Front view with open service door FigFront view Fig Safety in operation General safetyChild safety Coffee and espressoSpoon only ground coffee into the ground coffee filler Safety in cleaning and careDo not use steam to heat inflammable liquids Do not expose the coffee machine to the effects ofweatherSetting up and connecting the coffee machine Menu modeBefore using for the first time Overview of the menu itemsFilling the coffee bean container Switching on for the first timeFilling with water «TURN Steam KNOB»Setting the water hardness Switching on the machineSwitching off the coffee machine «TURNING OFFDetermining water hardness Setting and saving the water hard- ness levelMaking coffee with beans Hardness level 2, medium hard up to 2.5 mmol/l, orGram Programming the fill level, If the message «GROUND TOO Fine Adjust MillGo, to the setting, and run off Running the rinsing program Making several cups of coffee with the jug functionTips for making hotter coffee «ESPRESSO CUP PRE-GROUND 1 CUP» Using pre-ground coffeeFunction. The appliance displays e.g Centage indication «40%» Frothing milkClose the lid Machine is ready for the milk frothing120 sec. for the machine to automati Cleaning the steam nozzleTurn Knob for STEAM» Setting the language Setting the grinding textureMenu settings Preparing hot water«TEMPERATURE LOW» Setting the coffee temperatureSetting the shut-off time Setting the coffee program Programming the fill level Stages, using the scrolling keys or FigShows the number of jugs dispensed Cleaning the grinder Cleaning and CareRegular cleaning Emptying the waste coffee containerCleaning the brewing unit Proceed as followsTurn the knob for steam and hot water back to the position Running the descaling programUpper line of the display shows «50%»Shows the alternating messages Ordering AccessoriesWhat to do if you read fol- lowing messages on the display Waste coffee container is fullCoffee runs out too slowly Coffee is not hotCoffee is not creamy enough Coffee flows out of only one of the dispensers Brewing unit cannot be removed for cleaningCoffee runs out too quickly Remove the dried coffee with a needle FigPackaging material Technical DataDisposal Old applianceFor Austria If service is neededFor Repairs service 0810-955 For Product service 0810-955

CG 6400 specifications

The AEG CG 6400 is a state-of-the-art built-in gas cooktop designed to elevate your culinary experience with its innovative features and outstanding performance. Engineered with precision and user-friendliness in mind, this appliance makes cooking both enjoyable and efficient.

One of the standout features of the AEG CG 6400 is its high-quality stainless steel surface, which brings a touch of elegance to any kitchen. This durable material not only looks great but is also easy to clean, ensuring that maintenance is a breeze even after preparing elaborate meals.

The cooktop boasts powerful gas burners that deliver exceptional heat control, accommodating a wide range of cooking techniques from boiling and frying to simmering. With up to five cooking zones, including a multi-ring burner for intense heat, users have the freedom to prepare multiple dishes simultaneously, enhancing their cooking efficiency.

AEG has also integrated a flame failure safety device into the CG 6400, which automatically cuts off the gas supply if the flame goes out, offering peace of mind to the cooks in the kitchen. This feature significantly enhances safety, making it particularly suitable for homes with children or pets.

The cooktop’s ergonomic control knobs are placed at the front for easy access, allowing for precise flame adjustment while monitoring your cooking safely. Another notable technology is the integrated ignition system that allows for one-handed operation—simply turn the knob, and the burner ignites instantly, eliminating the need for matches or lighters.

Another characteristic that sets the AEG CG 6400 apart is its compatibility with a variety of cookware materials, including cast iron, stainless steel, and non-stick pans, making it versatile for all types of cooking. The cooktop also features robust cast iron grates that provide a stable and secure base for pots and pans, promoting better heat distribution.

In conclusion, the AEG CG 6400 is more than just a cooktop; it is an embodiment of quality, safety, and modern cooking technology. Its elegant design, powerful burners, user-friendly controls, and safety features make it an ideal choice for both professional chefs and home cooking enthusiasts alike. Whether you are searing meats, simmering sauces, or whipping up a quick stir-fry, the AEG CG 6400 delivers efficient performance that meets the demands of today’s cooking styles.
Top Page Image Contents