24
Operating instructions
1. Check the filters
Ensure they are clean and properly positioned (see "Maintenance and cleaning").
2. Press the On/off push button
The On/Off indicator light will come on.
3. Check that there is rinse aid and salt
The corresponding indicator lights will illuminate if refilling is necessary.
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5.Ensure that the spray arms can rotate freely.
6.Add the detergent
Add the required amount of detergent into the dispenser according to the dosage instructions in the "Washing programmes" chart.
Close the detergent dispenser lid.
7. Close the dishwasher door
8a. Setting and starting the programme without delay start
Press the push button corresponding to the wanted programme: the indicator light corresponding to the programme illuminates and the phase indicator lights for that programme start flashing.
The start of the programme will occur after about 6 seconds from the last pressure of a programme push button, in this time it is possible to change programme simply pressing the push button of another programme.
Once the programme has started the phase indicator lights will turn off except for the phase under way.
It is possible to interrupt the programme:
●opening the door
●pressing the On/Off (in this case all the indicator lights turn off)
Close the door again o press the On/Off, the programme will start from the point in which it was interrupted.