AEG 54710 operating instructions Installation, Levelling

Page 34

Installation

Fitting under a counter (kitchen worktop or sink)

By removing the machine’s worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture.

Proceed as follows:

-Remove the machine’s worktop by unscrewing the two front retaining screws, pull from the front and slide out the rear slots, lifting the worktop.

570-

600

820

450

IN04

34

Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.

Levelling

Good levelling is essential for correct closure and sealing of the door.

When the appliance is correctly levelled, the door will not catch on the levelling spacers on either side of the cabinet.

If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.

Image 34

Contents Favorit Dear customer Contents Safety instructions Using your dishwasher for its intended purposeYour dishwasher in day-to-day use Disposing of the packaging Disposing of packaging and old machineDisposing of your old machine Economical and ecological dishwashing Levelling spacers Description of the applianceInside of the appliance Upper basket stop WorktopIndicator lights Door handle On/Off indicator light On/Off push buttonBefore using your dishwasher for the first time Setting the water hardness rangeOnce, level 4 is selected To fill Filling with special saltOnly use salt specifically designed for use in dishwashers Rinse aid Compartment. Clean up any rinse aid spilt duringFilling with rinse aid Programme indicator light starts to flash Adjusting the dose Loading cutlery and dishes Lower basket To lower the prongsCutlery basket Upper basket Adjusting the height of the upper basketTo move to the higher position proceed as follows If using powder detergents proceed as follows Use of detergentCompact detergents with enzymes Washing programmes Cycle description Approximate values Press the On/off push button Operating instructionsCheck the filters Check that there is rinse aid and saltFor the formalities how to cancel a programme see point To cancel a programme in progressAt the end of the washing programme Page Internal and external cleaning Maintenance and cleaningCleaning the filters MA16 What to do, if Dishes are not clean Wash results are not satisfactoryCustomer service Technical specifications Hints for test centres Installation LevellingConnection instructions Water supply connectionsWater outlet connection Extension hosesProtection against flooding Electrical connectionFrom the Electrolux Group. The world’s No.1 choice