AEG 54710 operating instructions Water outlet connection, Extension hoses

Page 36

36

Water outlet connection

The end of the drain hose can be connected as follows:

1.To the sink outlet siphon, securing it if necessary with a clip.

2.Hooked over the edge of the sink using the special curved plastic guide provided.

3.To a wall outlet provided with vent-hole, minimum internal diameter 4 cm.

 

 

1

2

3

Ø

21

 

 

4 cm

 

 

min

 

18

 

 

Ø

 

 

 

 

 

 

 

 

 

max 100 cm

min 30 cm max 100 cm

CS09

 

 

 

 

The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the floor.

It makes no difference which way the drain hose faces, either to the right or left of the dishwasher.

Avoid bending or kinking the hose as this could prevent or slow down the discharge of water.

Extension hoses

The necessary extension hoses can be obtained from specialist shops or from our technical assistance centres.

The extension hose must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided.

Likewise the internal diameter of the couplings used for connection to the waste outlet must be no smaller than the diameter of the drain hose.

Arrange the extension hose horizontally along the floor and allow it to rise only where it is to be connected to the drain.

Ø 18

Ø 21

 

 

 

 

cm

min 30 cm max 100 cm

+ 2 m max

max 100

 

 

CS10

 

 

 

Image 36
Contents Favorit Dear customer Contents Safety instructions Using your dishwasher for its intended purposeYour dishwasher in day-to-day use Disposing of packaging and old machine Disposing of the packagingDisposing of your old machine Economical and ecological dishwashing Description of the appliance Inside of the applianceLevelling spacers Upper basket stop WorktopIndicator lights Door handle On/Off indicator light On/Off push buttonBefore using your dishwasher for the first time Setting the water hardness rangeOnce, level 4 is selected Filling with special salt To fillOnly use salt specifically designed for use in dishwashers Compartment. Clean up any rinse aid spilt during Rinse aidFilling with rinse aid Programme indicator light starts to flash Adjusting the dose Loading cutlery and dishes Lower basket To lower the prongsCutlery basket Adjusting the height of the upper basket Upper basketTo move to the higher position proceed as follows If using powder detergents proceed as follows Use of detergentCompact detergents with enzymes Washing programmes Cycle description Approximate values Operating instructions Check the filtersPress the On/off push button Check that there is rinse aid and saltTo cancel a programme in progress For the formalities how to cancel a programme see pointAt the end of the washing programme Page Maintenance and cleaning Internal and external cleaningCleaning the filters MA16 What to do, if Dishes are not clean Wash results are not satisfactoryCustomer service Technical specifications Hints for test centres Installation LevellingConnection instructions Water supply connectionsWater outlet connection Extension hosesProtection against flooding Electrical connectionFrom the Electrolux Group. The world’s No.1 choice